On-board electrical equipment specifications Characteristic Meaning System type 12 volt with minus on the case External lighting fixtures Lamps Power (W) Headlight 55/60 (H4) Fog light 55 (H1) Front side light 5 Direction indicator 21 Side direction indicator 5...
General description of troubleshooting in electrical systems An electrical circuit consists of electrical components, switches, relays, motors, fuses, reverse current relays, and wiring. To find the exact fault in an electrical circuit, the electrical connection diagrams are...
General description of fuses and relays Most fuses are located in the fuse box located in the passenger compartment on the driver's side of the vehicle. Additional fuses and some relays are located in the fuse/relay box on the left side of the engine...
Removal and installation switches Note: Before removing any switch, disconnect the ground cable from the battery and reconnect after installing the switch. Ignition switch/steering column lock 1. Insert the key into the ignition switch to lock the...
Replacement of lamps of external lighting devices Whenever replacing lamps, refer to the following paragraphs. a) Disconnect the ground cable from the battery. b) Remember, if the light has just been turned on, the lamp may be extremely hot. c) Always check the...
Replacement of interior lighting bulbs Follow the Section Replacing lamps (external lighting fixtures) , paragraph 1. Front interior light and reading light Models with a combined light unit 1. Using a flat-head screwdriver, carefully pry the headlight...
Removal and installation external light units Note: Before removing any module, disconnect the ground cable from the battery and reconnect the wire after installing the module. Headlight 1. Remove the bumper as described in Chapter Body . 2. Remove the front turn...
General description of headlight beam direction adjustment Fine adjustment is only possible with optical equipment and this work must be entrusted to a Renault service station or a workshop equipped accordingly. To adjust the headlight, turn the regulator located on the back of...
Removal and installation the instrument panel Removal 1. Disconnect the ground cable from the battery. 2. To access the screws securing the top of the instrument panel, carefully remove the left and right front speaker grilles using a screwdriver. 3a. Loosen the...
Removal and installation the multifunction display Removal 1. Remove the upper part of the instrument panel as described in Section Removal and installation the instrument panel . 2. Loosen the mounting screws and remove the multifunction display from the instrument...
Removal and installation the cigarette lighter Removal 1. Disconnect the ground cable from the battery. 2a. Remove the pull-out ashtray. 2b. Loosen the screws securing the ashtray bracket (refer to the illustrations). 3. Remove the ashtray mounting bracket from the...
Removal and installation the watch Removal 1. Remove the multifunction display as described in Section Removal and installation the multifunction display . 2. Carefully detach the watch and remove it from the display (refer to the accompanying...
Removal and installation sound signals Removal 1. The sound signals are installed behind the front bumper - one on the right side, the other on the left. 2. For better access, set the handbrake, then jack up the front of the car and support it on axle...
Removal and installation the windshield wiper arm Note: The wiper arms are very tight on their axles and will likely require a puller. Removal 1. Turn on the wiper motor, then turn it off so that the wiper arms return to their original position. 2. Lift the cover, then...
Removal and installation the windshield wiper motor and rod Removal All models except Scenic 1. Remove the battery. 2. Working through the battery opening, disconnect the wiring connector from the wiper motor. 3. Mark the positions of the motor shaft and crank, then remove the...
Removal and installation the rear window wiper motor Removal 1. Disconnect the ground cable from the battery, then remove the wiper arm as described in Section Removal and installation the windshield wiper arm . 2a. Press down the spindle cover. 2b. Unscrew the nut. 2c....
Removal and installation windshield/rear door washer system components Removal and installation 1. While working in the engine compartment, loosen the mounting nut/screw (where is available) and remove the washer reservoir filler neck. 2. Set the handbrake, then jack up the front of the...
Removal and installation the radio Note: The instructions below apply only to the procedures for removing and installing the original Renault radio. Removal 1. To release the radio mounting clamps in the instrument panel, insert a pair of welding...
Removal and installation speakers Removal 1. Using a flat-blade screwdriver, carefully pry the speaker grille off the instrument panel (refer to the accompanying illustration). Be careful not to damage the panel or grille. 2a. Remove the mounting...
Removal and installation the radio antenna Removal 1. The radio antenna mast is screwed into the assembly of its base and is removed extremely easily. 2. To remove the antenna assembly, you must first remove the overhead console. Slide the front cover of the...
Anti-theft alarm and engine immobilizer Note: The information below applies only to the anti-theft alarm and engine immobilisation systems supplied by Renault. On most of the models covered in this Manual, an anti-theft alarm system is included as standard....
Removal and installation front seat electric/heating components The replacement of the heating elements and the drive electric motors of the front seats should be entrusted to specialists of the car service. Such a replacement requires complete dismantling of the seat assembly. It...
Airbag System — Information and Precautions All models covered in this Manual are equipped with a supplemental restraint system (SRS), better known as airbags. Two airbags are included in the mandatory package. The system provides additional protection for the...
Removal and installation of airbag components See the warnings provided in Section Airbag system - general information and precautions . 1. Disconnect the negative battery cable, then remove the seat belt pretensioner and airbag fuse (sRS fuse) from its socket in...