Duster Fluence Kangoo Laguna Logan Megane Sandero Scenic Symbol Clio Other

Electrical equipment and appliances Renault Duster 1

Battery — Removal and Installation
Tightening torques Battery mounting bracket fastening bolt 12Nm Positive cable tip mounting bolt 6 Nm Battery negative cable terminal nut 6 Nm Removal Turn off the ignition. Caution! Before disconnecting the battery:...

Fuse box in the passenger compartment
The unit is installed in the passenger compartment on the left side of the dashboard. To access the relays and fuses in the passenger compartment, remove the access hatch cover. 1 - Passenger compartment fuse box

Fuse and relay box in the engine compartment
Version A Remove the fuse/relay box access cover. 2 - Engine compartment fuse and relay box Version B Remove the cover to gain access to the unit. 3 - Engine compartment fuse and relay box

Electronic anti-theft engine immobilizer system
Arrangement of elements 1 - Receiving ring 2 - Ignition switch 3 - UCHBS 4 - Ignition key

Ignition switch — removal and installation
Removal Disconnect the battery. Remove the receiving ring. Disconnect the wire connector from the holder at point (1) and (2) at the bottom of the instrument panel. Disconnect the connector using a flat-head...

Receiving ring — removal and installation
Removal Turn off the ignition. Note: It is not necessary to remove the steering wheel. Remove: two mounting bolts (1), lower steering column trim cover at point (2). Remove the upper steering column cover. Disconnect...

Power supply element for door locking ECU
Removal Loosen the screw (1). Use a flat-blade screwdriver to open the key at point (2). Remove the battery (3) using a flat-blade screwdriver. Installation Install the power supply element (3), observing the polarity....

Instrument cluster — removal and installation
Removal When replacing the instrument cluster, read the mileage counter indications on the instrument cluster and record them in the service book. Turn off the ignition. Unscrew the two lower mounting screws (1)....

Location of electric window components
1 - Passenger compartment fuse box 2 - Front door window switches 3 - Rear door window switches

Front door window switch
Removal Remove the audio system. Remove the center trim starting from the bottom. Disconnect the front left power window switch connector (1) or the front right power window switch connector (2). Disconnect the front...

Rear door window switch
Removal Disconnect the rear door window switch panel. Disconnect the rear window switch connector. Disconnect the rear door window switch by pressing the spring clips (1). Installation Latch the rear door window switch.

Switching unit in the engine compartment
New fuse and relay box in the engine compartment Remove the cover to access the junction box in the engine compartment. 1 - Switching unit in the engine compartment. The old fuse and relay box in the engine compartment...

List and location of wiring harnesses
1 - Passenger compartment fuse box 2 - UCHBS 3 - Engine compartment fuse and relay box 4 - ECU AVB-ESP 5 - Airbag control unit 6 - Audio system 7 - Injection system ECU

Diagnostic connector
The diagnostic connector (1) is installed in the glove compartment.

Front Bumper Wiring Harness
Removal Place the vehicle on a two-post lift. Turn off the ignition. Disconnect the battery. Remove the front bumper. Disconnect the fog light connectors (1). Disconnect the front bumper wiring harness at (2). Remove...

K4M Engine Wiring Harness
Tightening torques Bolt of the ground wire of the manual transmission 24 Nm Nuts for fastening the "mass busbar" 8 Nm Conventional designations A - Symbol for "mass" B - Fastening symbol (clamp, clamp, etc.) C - Symbol...

K9K Engine Wiring Harness
Conventional designations A - Symbol for "mass" B - Fastening symbol (clamp, clamp, etc.) C - Symbol of the female connector (connecting 2 wires) D - Symbol of the plug part of the connector (connecting 2 wires) Removal...

Front Interior Wiring Harness
Tightening torques: Ground wire fastening nuts - 8 Nm. Conventional designations A - Symbol for "mass" B - Fastening symbol (clamp, clamp, etc.) C - Symbol of the female connector (connecting 2 wires) D - Symbol of the...
Есть 1 comment

Rear Interior Wiring Harness
Tightening torques: Ground wire fastening nuts - 8 Nm. Conventional designations A - Symbol for "mass" B - Fastening symbol (clamp, clamp, etc.) C - Symbol of the female connector (connecting 2 wires) D - Symbol of the...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share with friends:

Other sections on other Renault models

➽ Electrical equipment: Equipment and devices Renault Clio 1 (1990-1998)
➽ Electrical equipment: Equipment and devices Renault Fluence 1 (2009-2020, petrol)
➽ Electrical equipment: Equipment and devices Renault Scenic 1 (1996-2003)
➽ Electrical equipment: Equipment and devices Renault Symbol 2 (2008-2013, petrol)
➽ Electrical equipment: Equipment and devices Renault Megane 1 (1995-2002)
➽ Electrical equipment: Equipment and devices Renault Logan 2 (2012-2020)

Link to this section in different formats

TEXTHTMLBB Code

Duster 1 (2009-2017)