Ignition key positions Stop and lock the steering shaft (ST) To lock the steering shaft, remove the key from the ignition and turn the steering wheel in one direction or another until the steering column lock is locked. To unlock the steering...
Starting and stopping the engine Engine starting To facilitate starting the engine at very low outside temperatures (below -20°С) turn on the ignition for a few seconds before turning on the starter. Make sure the electronic lock system is disabled....
Features of vehicles with a gasoline engine The following vehicle operating conditions: Continuous movement with the signal lamp of the minimum fuel level in the tank on; Use of leaded gasoline; Use of engine oil additives or fuels not approved by the...
Features of vehicles with a diesel engine The speed of rotation of the crankshaft of the diesel engine Diesel engines are equipped with an injection system that prevents the engine from exceeding the permissible engine speed, regardless of the gear engaged. If...
Gear shift lever Engaging reverse gear (on a stationary vehicle) Follow the gearshift diagram printed on knob 1. The reversing light comes on when the lever is moved to the reverse gear position (with the ignition on).
Parking brake Releasing the parking brake Slightly pull the lever 2 up and, pressing the button 3, lower the lever to its lowest position. Applying the parking brake Pull lever 2 up and check that the vehicle is safely braked.
Transmission — 4 wheel drive (4WD) 4X2 modes (2WD), 4X4 (4WD) Depending on the road conditions, you can select one of the following modes by turning switch 1: 2WD; AUTO; 4WD Lock. AUTO mode To select this mode, turn switch 1 to position «AUTO». Operating...
Driving correction and assistance systems Depending on the vehicle configuration, they include: ABS (anti-lock braking system); Emergency braking assistance system; ESP stability control system with understeer control and ASR traction control. ABS (anti-lock...
Automatic transmission 1 - Selector Display 3 on the instrument panel informs you about the selected mode and the selected gear. R: parking R: Reverse N: neutral position D: automatic mode 4: zone indicating the mode of operation of the...
Parking control system Operating principle Depending on equipment, the vehicle may be equipped with ultrasonic sensors integrated into the rear bumper. Built-in ultrasonic sensors in the rear bumper of the car «measure» the distance between...