Removing
Disconnect the battery.
Remove the receiving ring.
Disconnect the wiring harness from the holder at the point (1) And (2) below the dashboard.
Disconnect the connector using a flathead screwdriver.
Loosen the screw (3).
Set the ignition key to position (5).
Spread the retaining mustache (4).
Remove the switch.
Installation
Always replace the switch fixing screw.
Make sure the ignition key is in position (5).
Install:
- switch,
- switch mounting screw.
Fasten:
- ignition switch wiring harness
- block of wires of the ignition switch on the bracket.
Install the receiving ring.
Connect the battery.