Conventions
A - Symbol «masses»
B - Attachment symbol (collar, clip, etc.)
C - Symbol of the female part of the connector (2 wire connection)
D - Connector plug symbol (2 wire connection)
Removing
Disconnect the battery.
1 - Rear wiring harness on the floor
2 - Rear part of the interior wiring under the floor
3 - Rear part of the interior wiring on the body
4 - Rear of the interior wiring in the rear doors
5 - Rear part of the interior wiring in the tailgate
6 - Rear part of the interior wiring in the wheel arches
1 - Rear wiring harness on the floor
Remove:
- floor mat,
- lining of the middle pillar.
Raise the rear seat cushion.
2 - Rear part of the interior wiring under the floor
Place the car on a two post lift.
Move the fuel tank aside.
3 - Rear part of the interior wiring on the body
Remove:
- lining of the rear pillars of the body,
- rear shelf side panels
- upper lining of the rear pillars of the body,
- trunk lining,
- partially roof lining.
4 - Rear of the interior wiring in the rear doors
Remove an upholstery of a back door.
5 - Rear part of the interior wiring in the tailgate
Remove an upholstery of a door of a back.
6 - Rear part of the interior wiring in the wheel arches
Remove:
- rear wheels,
- ABS sensor cover.
1 - Rear wiring harness on the floor
Disconnect all connectors.
Disconnect part of the wiring at the indicated locations.
Remove part of the wiring.
2 - Rear part of the interior wiring under the floor
Disconnect all connectors.
Disconnect part of the wiring at the indicated locations.
Remove part of the wiring.
3 - Rear part of the interior wiring on the body
Work carried out on the right side of the vehicle
Disconnect all connectors.
Disconnect part of the wiring at the indicated locations.
Remove «mass» terminal at the specified location.
Remove part of the wiring.
4 - Rear of the interior wiring in the rear doors
Disconnect all connectors.
Disconnect part of the wiring at the indicated locations.
Remove part of the wiring.
5 - Rear part of the interior wiring in the tailgate
Disconnect all connectors.
Remove part of the wiring.
Disconnect part of the wiring at the indicated locations.
6 - Rear part of the interior wiring in the wheel arches
Disconnect all connectors.
Remove part of the wiring.
Disconnect part of the wiring at the indicated locations.
Installation
Installation is made in an order, the return to removal.
Torque tighten the wire nuts «masses» (8 Nm).
Connect the battery.