General information about the clutch The clutch is located between the engine and gearbox and is designed to disconnect and connect the flywheel mounted on the engine crankshaft and the gearbox input shaft. Pic. 3.1. Preparing to bleed the clutch slave...
Bleeding the hydraulic clutch release Attention! Be careful not to spill clutch fluid on painted surfaces. If this happens, immediately wash off the liquid with water. Note. Do not mix different brands of clutch fluids. Note. Do not reuse drained clutch...
Removal of air from the circuit between the tank and the fitting Install and lock the clutch pedal in the up position. Fill the reservoir with certified brake fluid. Attach installation (Ms. 554-07) to the hydraulic reservoir. Remove the plug from the bleed valve. Place a transparent...
Clutch pedal free play adjustment Disconnect the supply line between the reservoir and the clutch master cylinder. Close the tank opening. Add a small amount of certified brake fluid to the syringe. Insert the syringe into the supply line between the...
Clutch drive adjustment Pic. 3.2. Clutch drive adjustment: 1 - adjusting nut; 2 - locknut; 3 - cable sheath stopper; 4 - clutch release fork Adjust the clutch cable travel with the nut on the transmission side end (pic. 3.2). Loosen the...
Removal and installation of a cable of a drive of coupling Removing Pic. 3.4. Clutch cable In the engine compartment, disconnect the cable from the clutch release fork (pic. 3.4). Step on the pedal to retract the cable into the passenger compartment. Pic. 3.5. Removing the...
Removal and installation of the clutch pedal Removing Disconnect the wires from the battery terminals, starting with the negative terminal. Pic. 3.6. Removing the duct: 1 - air duct Remove the left bottom cover and air duct (pic. 3.6). Remove the gray...
Removal, adjustment and installation of the clutch pedal stroke sensor Attention! Handle the clutch pedal travel sensor with care. It is allowed to move the stem only when adjusting the size X (see fig. 3.9). Pic. 3.9. Clutch pedal travel sensor: 1 – sensor housing; 2 - rod Disconnect the...
Removal and installation of the clutch hydraulic pipeline Removing Place the car on a lift. Disconnect the battery. Remove the engine top cover and air intake grille. Pic. 3.10. Removing the air filter access panel fasteners: 1 – bolts of fastening of the panel of access; 2 -...
Clutch identification data Clutch cover with pressure plate assembly and clutch disc (engines K4J and K4M) External diameter of a conducted disk: 200 mm. Pic. 3.14. Clutch cover with pressure plate assy Thickness of a conducted disk: 6,9 mm....
Removal and installation of a flywheel Removing Remove the gearbox. Remove the clutch cover with pressure plate assembly. Pic. 3.30. Fixing the flywheel with a retainer (Mot. 582-01): 1 - latch Install retainer (Mot. 582-01) (pic. 3.30). Remove the flywheel...