Contents: Removal 🠛 Installation 🠛
Removal
Remove the gearbox.
Fig. 3.18. Flywheel fixation: 1 – retainer
Install the latch (Mot. 582-01) (Fig. 3.18).
Loosen the clutch housing mounting bolts.
Remove the clutch slave disc.
Use a vacuum cleaner or a clean cloth to remove dust from the clutch housing. Do not use compressed air, as inhaling dust containing asbestos is harmful to health.
Check the condition of the flywheel friction surface for cracks, burns and surface wear.
Check the condition of the friction linings of the driven clutch disc and if there are traces of oil or mechanical damage, replace the driven disc.
Caution: Clean the gearbox input shaft splines and install the assembly without using grease.
Installation
Install the clutch slave disc.
Fig. 3.19. Centering the driven disk: 1 – mandrel
Center the driven disk using the mandrel (Emb. 1518) (Fig. 3.19).
Tighten the mounting bolts crosswise in several steps.
Tighten the clutch housing mounting bolts to the specified torque (20 Nm) (k4J and K4M engines).