Contents: Removal 🠛 Installation 🠛
Removal
Remove the gearbox.
Remove the clutch housing with the pressure plate assembly.
Fig. 3.30. Fixing the flywheel with a locking device (Mot. 582-01): 1 – retainer
Install the latch (Mot. 582-01) (Fig. 3.30).
Loosen the flywheel mounting bolts, remove the flywheel and retainer (Mot. 582-01).
Fig. 3.31. Securing the flywheel with a locking device (Mot. 1677): 1 – retainer
Install the retainer (Mot. 1677) (Fig. 3.31).
Loosen the flywheel mounting bolts, remove the flywheel and retainer (Mot. 1677).
Installation
Clean the threaded holes on the crankshaft flange for the flywheel mounting bolts.
Degrease the flywheel bearing surface on the crankshaft flange.
Check the condition of the flywheel.
Fig. 3.32. Installation of spacer: 1 – spacer
[The original can be found on the website: www.Renaultbook.ru]
Install the spacer, observing the installation direction: chamfer towards the flywheel (Fig. 3.32).
Caution! Re-use of removed bolts is not permitted.
Apply LOC-TITE FRENETANCH to new flywheel bolts.
Fig. 3.33. Flywheel mounting bolt tightening sequence
Tighten in the order shown in Figure 3.33 to the required torque:
- flywheel mounting bolts (k engines) (65 Nm);
- flywheel mounting bolts (f4R engine) (70 Nm).