Required special tool
- Mot. 582 or Mot.582-01 Retainer.
Tightening torques, Nm
- Flywheel bolt: 20 + 60°.
Removing
1. Remove the pressure and driven disc.
2. Remove the flywheel mounting bolts (do not reuse bolts).
Attention! Regrinding of the friction surfaces of the flywheel is not allowed.
Installation
1. Clean the threads of the flywheel mounting bolts on the crankshaft.
2. Remove grease from the flywheel bearing surfaces on the crankshaft.
3. Install the flywheel, locking it with the tool Mot 582 or Mot 582-01.
Note. The flywheel bolts must be replaced periodically.