Front fender protectors Removing 1. Detach the trim at its top in direction 1. 2. Remove the three spring holders A, and then remove the expander.
Threshold panel Removing 1. Remove the front fender trim. 2. Disconnect the lower section of the body side at its upper part in direction 1. Detach the lower part of the body side at its lower part A. 3. Turn away nuts In, then remove...
Rear protection panel Removing 1. Loosen one or more screws A on the inside. 2. Remove the fasteners. Installation Install the clips in the corresponding places of the panel, then, pressing these clips to the corresponding holes in the car...
Hood — general information Removing Loosen the nuts securing the hood to the hinges A. It is recommended to perform the operation with two people. Installation The hood is installed in the reverse order. Adjust the gaps specified in paragraph...
Front fender Removing 1. Remove the plastic facing in place A on the side of the wing. 2. Remove the plastic fenders. 3. Remove the bumper with impact pad. 4. Remove the side turn signal. 5. Remove the front fender by removing 8 x...
Outside rearview mirror Removing 1. Remove the inner cover. 2. Remove the fastening nuts. 3. If there is an electric drive, disconnect the wiring harness. Removing the mirror glass Remove the mirror glass using the Sag tool. 1363.
Dashboard Removing 1. Disconnect the battery. 2.1. Removing the steering wheel (along with airbag). Remove the two airbag mounting screws located behind the steering wheel. Disconnect electrical connectors. Remove the airbag....
Console — general information 1. Remove the gearshift boot retainers. 2. Remove the four fixing screws. 3. Disconnect electrical connectors.