Drive Shafts — Technical Data Table 5.4. Technical data Table 5.5. Materials used Required special tool B.Vi 31-01 Barb set. Rou. 604-01 Wrench for hub nut. T. Av. 476 Ball joint puller. T. Av. 1050-02 Drive shaft puller. Tightening torques, Nm...
Drive shafts — removal and installation Removing 1. Place the vehicle on a two post lift. 2. Drain the gearbox oil. 3. Remove the floating brake caliper (hang it to the chassis parts). 4. Remove the wheel hub nut, Rou wrench. 604-01. 5. On the left side,...
Inner joint cover GI69 Required Tool T. Av. 1168 Clamp cutters CAILLAU. T. Av. 1256 Crimping tool OETIKER. T. Av. 1331 Mandrel for installing the hinge boot. 1 - Three-thorn; 2 - Rubber cover; 3 - Support ring; 4 - Holder; 5 - Dirt deflector;...
Inner joint cover RC 462 Removing 1. Cut through two clamps 5 without damaging the groove on the hinge body. 2. Remove as much grease as possible. 3. Remove the hinge housing. 4. Remove the retaining ring. 5. Mark the position of the three-stud...
Cover for external hinge GE 86 1 - Hinge body; 2 - Three-thorn; 3 - Roller; 4 - Shaft hinge holder; 5 - Polymer case; 6 - Clamps; 7 - Spring; 8 - Pusher; 9 - Washer; 10 - The ring gear of the ABS wheel sensor. Removal and installation 1. Remove both...