Drive shafts — general information 1. Drive shaft. 2. Steering knuckle. 3. Wheel bearing 4. Front wheel speed sensor 5. Brake disc guard. 6. Rubber ring steering knuckle. 7. Wheel hub. 8. Gyka drive shaft. 9. Front brake disc. 10. Brake caliper.
Repair Precautions When performing any work related to lifting the vehicle on a lift, observe the relevant safety regulations. Attention: To avoid permanent damage to the front hub bearing: Do not loosen or tighten the drive shaft nut...
Front left drive shaft Removal and installation of the front left drive shaft Removing the drive shaft Attention: To avoid permanent damage to the front hub bearing: Do not loosen or tighten the drive shaft nut when the vehicle wheels are on...
Front right drive shaft Removal and installation of the front right drive shaft Removing the drive shaft Attention: To avoid permanent damage to the front hub bearing: Do not loosen or tighten the drive shaft nut when the vehicle wheels are on...
Replacing the boot of the drive shaft from the side of the wheel 1. Large boot collar. 2. Small boot collar. 3. Anther of the drive shaft. 4. Ball cage. 5. Stub axle housing. 6. Ball cage. 7. Drive shaft. 8. Balls. 9. Retaining ring. Attention: When performing work, use sealed gloves...
Replacing the anther of the left front drive shaft on the gearbox side 1. Small boot collar. 2. Anther drive shaft. 3. Retaining ring. 4. Cross. 5. Retaining ring. 6. Ball bearing. 7. Reflector. 8. Drive shaft. Attention: When performing work, use sealed gloves (nitrile). Removing the...
Replacing the anther of the right front drive shaft on the gearbox side 1. Reflector. 2. Drive shaft. 3. Driveshaft joint housing. 4. Cross. 5. Retaining ring. 3. Spring. 7. Anther drive shaft. 8. Small boot collar. 9. Large collar boot. Attention: When performing work, use sealed gloves...
Differential seals Removing differential seals 1. Place the vehicle on a two post lift. 2. Unscrew the fastening bolts and remove the engine protective tray. 3. Drain the oil from the gearbox. Oil seal on the left side of the differential...
Differential bearings Removing the differential bearing 1. Remove the gearbox. 2. Place the gearbox on a dismantling stand. 3. Remove the fifth gear housing. 4. Remove the synchronizer and gears of the fifth gear. 5. Remove the gearbox...
Special tools and fixtures Name of tool and fixtures Catalog number Ball joint puller Tav. 476 Pin remover Emb. 880 Universal grip for pullers (disc with hooks without slider) Tav. 1050-04 Screw extractor Tav. 1420, Tav.1050-04, Tar. 1454, Tar....