Features of the lighting system design Headlights. Automobiles use headlights that combine a dual-filament low-beam and high-beam lamp, a side light lamp, and a turn signal lamp. Fog lights. Some vehicles are equipped with fog lights installed in the lower...
Replacing lamps in lighting fixtures For headlight bulb replacement perform the following operations. Note: For clarity, replacing the bulbs is shown on a removed headlight. 1. Open the hood. 2. Disconnect the wire from the negative terminal of the...
Headlight replacement You will need: a 10 mm socket head and an extension. 1. Disconnect the wire from the negative terminal of the battery. 2. Remove the front bumper (see "Removing and installing the front bumper" ). 3. Remove the...
Replacing the headlight corrector 1. Disconnect the wire from the negative terminal of the battery. 2. Remove the headlight (see "Replacing the headlight" ). 3. Press the lock, turn the corrector clockwise... Note: The right headlight corrector must be...
Replacing the rear light 1. Disconnect the wire from the negative terminal of the battery. 2. Remove the trunk trim on the side of the light being replaced (see "Removing and installing trunk trim" ). 3. Press the lock and disconnect the wiring...
Replacing the license plate light 1. Disconnect the wire from the negative terminal of the battery. 2. Press the release tab and remove the license plate light from the opening in the rear bumper. 3. Disconnect the wiring harness connector... 4. ...and...
Replacement of interior light 1. Disconnect the wire from the negative terminal of the battery. 2. Remove the interior light diffuser by overcoming the force of the clamps. 3. Press the lock... 4. ...and remove the lampshade from the hole in the...
Replacement of the trunk light 1. Disconnect the wire from the negative terminal of the battery. 2. Press the latch... 3. ...and remove the lamp from the hole in the car body. 4. Press the lock, disconnect the wiring harness connector from the lamp...
Replacing the side turn signal light 1. Disconnect the wire from the negative terminal of the battery. 2. Pull the flashlight towards you and, overcoming the force of the clamps... 3. ...remove it from the hole in the wing. 4. Disconnect the bulb holder by...