Headlights — removal and installation, lamp replacement, dimmer Note. The headlight and direction indicator are mounted in one unit. Removing disconnect the wire from the negative terminal of the battery; remove the front bumper and grille (see section « Body »); Figure 8.19....
Replacement of lamps of lighting devices Replacing the position lamp Figure 8.22. Disconnecting the side light bulb connector In the engine compartment, disconnect the connector from the parking light bulb (Figure 8.22). Turn the bulb housing counterclockwise...
Fog lights — removal and installation Option 1 1. Disconnect the fog lamp connector. 2. Remove two screws (A) headlight mounts, remove the headlight. Installation is carried out in the reverse order. After installation, adjust the position of the headlight...
Rear lights — removal and installation Figure 8.28. Rear light connector In the luggage compartment, remove the rear light mounting bolt. From outside the vehicle, disconnect the lamp from the body by removing it from the guide tabs. Disconnect the connector...
Additional brake light Replace brake light bulb (12 V. 21 W). Hatchback body Figure 8.30. screws (A) fastening of the upper panel of the tailgate Figure 8.31. Fastening latches (IN) chute top and screws (WITH) fastening of a lantern of the...
License plate lighting Figure 8.33. Removing the license plate light from the rear bumper Figure 8.34. Removing the diffuser from the license plate light Carefully pry the light out of the bumper using a thin-blade screwdriver (Figure 8.33)....
Interior ceiling lamp — removal and installation Ceiling lamp without individual lighting Figure 8.35. Removing the dome light: And – a groove for removal of a plafond; B - groove for removing the diffuser Unclip the cover from the roof lining using a small...
Trunk light cover — removal and installation Figure 8.38. Removing the luggage compartment light Using a thin-blade screwdriver, pry and remove the lighting lamp, disconnect the diffuser and replace the lamp if necessary «finger» type (Figure 8.38). Installation...
Headlight range control and its switch The headlight beam corrector changes the illumination of the road in the vertical plane depending on the vehicle load. The corrector control unit is located on the left side of the instrument panel. Figure 8.58....
Headlight adjustment The direction of the light beams of the headlights should be such that the road in front of the car is well lit, and the drivers of oncoming vehicles are not blinded by the light of the low beam headlights. Figure 8.20....