Angles of installation of forward and back wheels Note: Before checking and adjusting the wheel alignment, check and, if necessary, adjust the tire pressure. Table. Tire pressure Tire size Tire pressure, kPa front Rear 175/65R14T, 185/60R14H 190 180 175/70R13T,...
Front suspension — design description The independent type front suspension with McPherson type shock absorbers, lower wishbones and anti-roll bar is mounted on a subframe. The shock absorber struts with twisted coil springs are attached to the reinforced...
Replacing the front shock absorber Tightening torques: Shock absorber support bolt - 180 Nm Travel stop nut - 60 Nm Wheel bolt - 90 Nm Removing turn on the parking brake; raise the front of the vehicle, place safety supports under the body and remove the...
Dismantling and repair of the shock absorber Strut strut details: 1 - upper spring plate; 2 - thrust washer; 3 - support bearing; 4 - top support of the rack; 5 - shock absorber rod nut; 6 - spring; 7 - shock absorber; 8 - compression buffer with protective cover...
Replacing the anti-roll bar Tightening torques: Center bearing bolt - 30 Nm Stabilizer arm nut - 15 Nm Removing 1. Put the car on a lift. 2. Turn away two lower bolts of fastening of a reception pipe of system of release. 3. Remove the two...
Removing the steering knuckle Withdrawal: turn on the parking brake; raise the front of the vehicle, place safety supports under the body and remove the appropriate wheel; unscrew the hub nut (see subsection « Front wheel drive »); unscrew the two...
Lower suspension arm and arm bushings Special tool: Clamp - Sus. 1414-01 Tightening torques: Wheel bolt - 90 Nm Gwicks for attaching the lever to the subframe - 90 Nm Nut for fastening the lever to the hub - 55 Nm Stabilizer mounting nuts - 15 Nm Removing...
Ball joint replacement Removing If the ball joint boot is damaged, replace the ball joint assembly. turn on the parking brake; raise the front of the vehicle, place safety supports under the body and remove the appropriate wheel; unscrew the...