Automatic transmission Renault Symbol 1

General information about automatic transmission
Fig. 4.34. Location of sensors in an automatic transmission: 1 – pressure sensor; 2 – output speed sensor; 3 – electromagnetic valve for controlling the flow of cooling liquid; 4 – input speed sensor The vehicle is...

Draining and filling the automatic transmission fluid
The working fluid is filled into the gearbox for its entire service life. During operation, small leaks may occur, which will require adding oil to the level. The working fluid is replaced only if there is certainty...

Removal and installation of automatic transmission
Attention! If a new torque converter or gearbox is to be installed, reprogram the ECU using the XR25 tester. Do not remove the transmission from the vehicle for the intended repair until a professional diagnosis has...

Removal and installation the selector lever
Removal procedure: place the car on a lift or raise the front of the car and place the body on safety supports; disconnect the negative battery cable; remove the center console in the car's interior (see section " Body...

Adjusting the selector cable
Adjustment procedure: move the selector lever to the "N" position; disconnect the selector cable end from the multifunction switch on top of the transmission; Fig. 4.39. Gearbox modular connector (arrow) press on the...

Removal and installation the selector cable
Removal procedure: remove the selector lever as described above; remove the air intake duct; disconnect the selector cable end from the multifunction switch on top of the transmission. Release the outer cable sheath...

Removal, installation and adjusting the multifunction switch
The multi-function switch informs the ECU of the position of the gear selector lever, preventing the starter from starting when gears are engaged and controlling the reversing lights. The switch is mounted on top of the...

Replacing the differential seal
Replacement procedure: disconnect the negative battery cable; place the vehicle on a lift and drain the transmission fluid as described above; remove the front wheel from the desired side; disconnect the drive shaft...

Replacing the torque converter seal
Replacement procedure: remove the gearbox; carefully remove the torque converter from the gearbox shaft; Caution! Be careful - there is a lot of working fluid in the torque converter, which may leak out during the...

Replacing automatic transmission sensors
Fig. 4.47. Location of sensors on the gearbox: 1 – torque converter turbine speed sensor; 2 – speed sensor; 3 – electromagnetic valve for regulating the cooler capacity; 4 – pressure sensor in the pressure line The...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share with friends:

Other sections on other Renault models

➽ Transmission: Automatic gearbox Renault Megan 2 (2002-2009, petrol)
➽ Transmission: Automatic gearbox Renault Clio 1 (1990-1998)
➽ Transmission: Automatic gearbox Renault Sandero 1 (2007-2012, petrol)
➽ Transmission: Automatic gearbox Renault Fluence 1 (2009-2020, petrol)
➽ Transmission: Automatic gearbox Renault Laguna 2 (2001-2007)
➽ Transmission: Automatic gearbox Renault Espace III (1996-2002)

Link to this section in different formats

TEXTHTMLBB Code