Specifications for automatic transmission DPO Vehicles with DP0 automatic transmissions are equipped with «Shift lock and lock up». System «Shift Lock» blocks the movement of the selector lever if the brake pedal is not pressed at the same time. Note. When...
Safety precautions when working with automatic transmissions 1. The automatic transaxle is composed of high-precision parts, which requires careful inspection before reassembly, because even a small scratch may cause fluid leakage or affect performance. The repair instructions...
Draining the oil from the automatic transmission Oil used The oil is filled into the automatic transmission DP0 for the entire period of operation. Therefore, the box does not need maintenance. In the case of small leaks, only topping up the oil is carried out. Oil...
Filling with automatic transmission oil Filling is carried out through the appropriate opening. Use a 15/100 mesh filter funnel to avoid contamination. Filling and checking the oil level Park the vehicle on a level, level surface. Disconnect the wires from...
Checking torque converter lockup Place the car on a two post lift. Raise the car until the wheels are off the floor by a few centimeters. Connect the diagnostic tool (CLIP). Enter into a dialogue with the automatic transmission computer. Monitor the...
Pressure measurement in the pressure line Necessary fixtures and special tools: special device (Bvl. 1215-01); automatic transmission oil pressure test kit (in a case); pressure gauge 25 bar. Some automatic transmission diagnostic procedures require the...
Removal and installation of the hydrodistributor Removing Place the car on a two post lift. Remove the engine top covers. Remove the battery cover. Disconnect the wires from the battery terminals, starting with the negative terminal. Remove the engine undertray. Drain...
Leaf Spring Lever Adjustment Hold the multifunction switch lever in the full position (in the forced first gear position) using a plastic clamp and a bolt screwed into the gearbox housing. Loosen bolt 1. Install the leaf spring arm. by inserting...
Removal and installation of an automatic transmission Attention! To prevent damage to the contact disc under the steering wheel, observe the following instructions: before disconnecting the steering shaft from the steering mechanism, be sure to block the steering wheel...
Removing and installing the multifunction switch Removing Set the selector lever to position «N». Disconnect the wires from the battery terminals, starting with the negative terminal. Remove: air intake pipe; battery; battery shelf; injection computer with bracket;...
Multifunction switch adjustment With the gear selector in the neutral position, attach two meter tips to the position test leads. Set the multimeter to «ohmmeter». Turn the multifunction switch manually until the switch closes (resistance on switch...
Removal and installation of automatic transmission computer Removing Place the car on a two post lift. Remove the top engine cover. Disconnect the wires from the battery terminals, starting with the negative terminal. Remove the front bumper. Disconnect the ECU connector and...
Replacing the automatic transmission computer Note. When an automatic transmission computer is replaced, it is necessary to memorize the new computer with the value of the gearbox oil life stored in the memory of the replaced computer. Proceed as follows: read out...
Vehicle speed and torque converter turbine rotation sensors Removing Place the car on a two post lift. Remove the engine top covers. Disconnect the wires from the battery terminals, starting with the negative terminal. Note. It is not necessary to drain the oil and remove the...
Electromagnetic valves of the hydrodistributor 1 - solenoid pressure control valve; 2 - solenoid valve for blocking the torque converter; 3 - solenoid valve No. 4 of the gear shift sequence; 4 - solenoid valve No. 3 of the gear shift sequence; 5 - solenoid valve No....
Summary table of malfunctions of an automatic transmission Summary table of malfunctions of an automatic transmission Assignment of diagnostic contacts of the computer Interpreting status displays with the diagnostic tool Status of shift sequence solenoid valves Status of shift...
Troubleshooting and Compliance with Diagnostic Codes Note. The check is carried out with the engine running at idle, with the consumers of electricity turned off. Note. Check is carried out on the idle engine at the switched-off ignition.