Duster Fluence Kangoo Laguna Logan Megane Sandero Scenic Symbol Clio Other

Vehicle passive safety system Renault Laguna 2

Airbags and seat belt pretensioners
These vehicles are equipped with a set of passive safety devices related to programmable restraint systems (SRP), including: driver's front airbag with dual-section inflatable chamber of programmable restraint system;...

75-pin adapter (B53)
The adapter is connected instead of the ECU. It allows you to monitor all ignition circuits and measure the ECU supply voltage using XRBAG, NXR or CLIP devices. The adapter's outputs also allow you to check the...

SRS ECU locking procedure
Before removing the ECU or before carrying out any work on the airbag and seat belt pretensioner system, be sure to lock the ECU using the NXR, OPTIMA 5800 and CLIP tools. 1. Select the menu "Renault car diagnostics"....

Removal and installation the SRS ECU
The ECU is located in the tunnel in the center console. Attention! Before removing the ECU, be sure to lock it using one of the diagnostic devices. Removal Remove the center console. Cut the mat at the indicated place 1...

SRS ECU Configuration
New ECUs that can be identified by the "ACU3" index using diagnostic tools (except XR25), are supplied in the configuration for "front side airbag, rear side airbag and curtain airbag". If the configuration setting is...

Carrying out work with ignition circuit wires
If a fault is detected in one of the wires, such a wire cannot be repaired and must be replaced. This safety element is not intended for use with normal wiring or connector repair methods. Since the airbag and seat belt...

Seat belt pretensioners
Description Cars are equipped with different types of seat belt pretensioners. Pretensioners for both front seat belt buckles. They are installed on the sides of the front seats. Driver's lap belt pretensioner....

Removal and installation front seat belt pretensioners
Attention! It is prohibited to carry out any work with pyrotechnic systems (seat belt pretensioners or air bags) near a heat source or open flame, as there is a risk of them being triggered. Caution! Before removing the...

Removal and installation rear seat belt pretensioners
The pretensioner is located on the reel. To remove it, you need to remove the trunk trim and the side panel trim. Removal Disconnect the connector and ground wire and remove the mounting bolt. Installation Pay attention...

Passenger airbag module
The passenger side airbag (SRP) is equipped with an inflatable chamber with two sections. This airbag has a seat belt located opposite it. Therefore, for this type of airbag, an additional adjustment of the programmable...

Side airbag module (front)
Description The side airbag module is installed in the backrest of the front seat on the door side. It includes: inflatable chamber; non-detachable pyrotechnic gas generator with igniter. When deployed, the airbag tears...

Side inflatable curtain module
Description The side curtain airbag module or passenger head airbag module is installed under the headliner. The module includes: inflatable chamber in the form of a curtain; pyrotechnic gas generator with igniter...

Rear side airbag module
Description The rear side airbag module 1 is installed under the trim at the level of the rear seat cushion. The module includes: inflatable chamber in the form of a curtain; non-detachable pyrotechnic gas generator...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share with friends:

Other sections on other Renault models

➽ Electrical equipment: Safety system Renault Fluence 1 (2009-2020, petrol)

Link to this section in different formats

TEXTHTMLBB Code