Share with friends:
Car headlights and lighting Renault Laguna 2
Removal and installation of headlights (all types)
Remove the decorative covers. Disconnect the battery and headlight connectors. Attention! Xenon lamps light up when a voltage of 20,000 V is applied and operate at an alternating voltage of 85 V. Therefore, before...
Remove the decorative covers. Disconnect the battery and headlight connectors. Attention! Xenon lamps light up when a voltage of 20,000 V is applied and operate at an alternating voltage of 85 V. Therefore, before...
Replacing headlight bulbs
High beam lamps The lamp is replaced after removing the plastic casing 1. Note: To replace high beam bulbs, use only H1 bulbs recommended for use by Renault. Sidelight and low beam lamps The lamps are replaced after...
High beam lamps The lamp is replaced after removing the plastic casing 1. Note: To replace high beam bulbs, use only H1 bulbs recommended for use by Renault. Sidelight and low beam lamps The lamps are replaced after...
Features of daytime running lights
In the version for some countries, the daytime running lights are controlled by the central electronic switching unit (UCH). In addition, the fuse and relay box has special jumpers to supply power to the exterior...
In the version for some countries, the daytime running lights are controlled by the central electronic switching unit (UCH). In addition, the fuse and relay box has special jumpers to supply power to the exterior...
Headlight corrector — removal and installation
Removal/installing the control unit Open the fuse box cover so that you can reach in and press on the tabs 1. Disconnect the control unit holder. Disconnect the connector and then remove the control unit from the...
Removal/installing the control unit Open the fuse box cover so that you can reach in and press on the tabs 1. Disconnect the control unit holder. Disconnect the connector and then remove the control unit from the...
Fog lights — removal and installation
Removal Remove: radiator trim; engine crankcase protection; front bumper. Remove the mounting screws B. Note: It is not necessary to remove the front bumper to remove the left front fog light assembly. Installation...
Removal Remove: radiator trim; engine crankcase protection; front bumper. Remove the mounting screws B. Note: It is not necessary to remove the front bumper to remove the left front fog light assembly. Installation...
Xenon headlights — design description
General information In accordance with European standards, these vehicles are required to be equipped with a system for automatically adjusting the headlight beams in the vertical plane depending on the height of the...
General information In accordance with European standards, these vehicles are required to be equipped with a system for automatically adjusting the headlight beams in the vertical plane depending on the height of the...
Removal the rear height sensor
Removal Remove the left rear wheel. Disconnect: end of thrust; nut 1 of the holder. Disconnect the connector and remove the sensor with the holder. Remove the bolts and disconnect the sensor from the holder 2....
Removal Remove the left rear wheel. Disconnect: end of thrust; nut 1 of the holder. Disconnect the connector and remove the sensor with the holder. Remove the bolts and disconnect the sensor from the holder 2....
Removal and installation the front sensor and ECU
Removal Remove the left front wheel. Disconnect the ball joint A connected to the lower triangular suspension arm and unscrew the mounting bolts B. Disconnect the connector and remove the sensor. Installation Attention!...
Removal Remove the left front wheel. Disconnect the ball joint A connected to the lower triangular suspension arm and unscrew the mounting bolts B. Disconnect the connector and remove the sensor. Installation Attention!...
Removal and installation of xenon headlights
The procedure for removing/installing headlights equipped with xenon lamps is the same as for other types of headlights. Attention! Xenon lamps light up when a voltage of 20,000 V is applied and operate at an...
The procedure for removing/installing headlights equipped with xenon lamps is the same as for other types of headlights. Attention! Xenon lamps light up when a voltage of 20,000 V is applied and operate at an...
Removal actuators
Removal Remove the decorative cover and move the power steering reservoir aside (if necessary). Disconnect the actuator connector. Tighten the adjusting screw A (no more than six turns). Rotate the actuator one eighth...
Removal Remove the decorative cover and move the power steering reservoir aside (if necessary). Disconnect the actuator connector. Tighten the adjusting screw A (no more than six turns). Rotate the actuator one eighth...
Removal the xenon lamp
Removal Attention! Xenon lamps light up when a voltage of 20,000 V is applied and operate at an alternating voltage of 85 V. Therefore, before removing it, it is necessary to disconnect the headlight connector and wait...
Removal Attention! Xenon lamps light up when a voltage of 20,000 V is applied and operate at an alternating voltage of 85 V. Therefore, before removing it, it is necessary to disconnect the headlight connector and wait...
Electronic control unit
Attention! Xenon lamps light up when a voltage of 20,000 V is applied and operate at an alternating voltage of 85 V. Therefore, before removing it, it is necessary to disconnect the headlight and wait until the ECU...
Attention! Xenon lamps light up when a voltage of 20,000 V is applied and operate at an alternating voltage of 85 V. Therefore, before removing it, it is necessary to disconnect the headlight and wait until the ECU...
Initializing the system and adjusting the headlights
This procedure must be performed every time after working on the headlight, sensor or chassis. Place the car on a level, horizontal surface. Caution! Do not apply the parking brake. Make sure the vehicle is unloaded and...
This procedure must be performed every time after working on the headlight, sensor or chassis. Place the car on a level, horizontal surface. Caution! Do not apply the parking brake. Make sure the vehicle is unloaded and...
Rear lights (hatchback)
On hatchback-type cars, the taillights are divided into two parts, one light is located on the wing and the other on the tailgate. Removal the lights on the wings Remove rear stopper A. Remove the flashlight and...
On hatchback-type cars, the taillights are divided into two parts, one light is located on the wing and the other on the tailgate. Removal the lights on the wings Remove rear stopper A. Remove the flashlight and...
Removal the lights on the trunk lid
Remove the rear stopper D. Remove the flashlight and disconnect the connector. To access the lamps, detach the lamp holder by pressing the spring latch E. Note: Some models use a bolt and nut instead of the D stopper....
Remove the rear stopper D. Remove the flashlight and disconnect the connector. To access the lamps, detach the lamp holder by pressing the spring latch E. Note: Some models use a bolt and nut instead of the D stopper....
Removal the wing light (station wagon)
Removal To remove the rear lights, it is not necessary to remove the bumper. Installation Place the lantern back in place. Tighten the fastener on the wing A and then the fasteners on the tailgate side B. Connection...
Removal To remove the rear lights, it is not necessary to remove the bumper. Installation Place the lantern back in place. Tighten the fastener on the wing A and then the fasteners on the tailgate side B. Connection...
Removal the high brake light
To remove the high brake light, you need to remove the trim of the tailgate or luggage compartment door (see section " Body "). Note: Hatchbacks are equipped with a brake light with an incandescent bulb. Station wagons...
To remove the high brake light, you need to remove the trim of the tailgate or luggage compartment door (see section " Body "). Note: Hatchbacks are equipped with a brake light with an incandescent bulb. Station wagons...
Interior lighting devices
Peculiarities Depending on the configuration, cars can be equipped with: independent lights for illuminating the lower part of the doors (light up when the corresponding door is opened); lampshades (front and back) with...
Peculiarities Depending on the configuration, cars can be equipped with: independent lights for illuminating the lower part of the doors (light up when the corresponding door is opened); lampshades (front and back) with...
This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
Other sections on other Renault models
➽ Electrical equipment: Headlights and lighting Renault Sandero 1 (2007-2012, petrol)
➽ Electrical equipment: Headlights and lighting Renault Fluence 1 (2009-2020, petrol)
➽ Electrical equipment: Headlights and lighting Renault Scenic 1 (1996-2003)
➽ Electrical equipment: Headlights and lighting Renault Logan 1 (2004-2012, petrol)
➽ Electrical equipment: Headlights and lighting Renault Symbol 2 (2008-2013, petrol)
➽ Electrical equipment: Headlights and lighting Renault Megan 2 (2002-2009, petrol)
Link to this section in different formats
TEXTHTMLBB Code
- General information
- User manual
- Maintenance
- Power unit
- Engine repair
- Cooling system
- Fuel system
- Fuel injection (petrol)
- Power system (petrol)
- Fuel injection (diesel)
- Fuel system (diesel)
- Exhaust system
- Transmission
- Clutch
- Mechanical gearbox
- Automatic gearbox
- Drive shafts
- Chassis, running gear
- Wheels and tires
- Car suspension
- Steering
- Brake system
- Body and interior
- Exterior (external elements)
- Doors, locks and windows
- Electrical equipment
- Power devices
- Equipment and devices
- Headlights and lighting
- Breakers and switches
- Safety system
- Electrical circuits