Contents: Removal 🠛 Installation 🠛
Removal
Attention! Xenon lamps light up when a voltage of 20,000 V is applied and operate at an alternating voltage of 85 V.
Therefore, before removing it, it is necessary to disconnect the headlight connector and wait until the ECU cools down.
It is prohibited to turn on the lamp if it is not installed in the headlight unit (it is dangerous for eyesight).
Disconnect the lamp connector by turning it a quarter turn counterclockwise.
Press the spring clips and remove the lamp.
Caution! Protect the lamp from impacts, as its outer conductor 1 is very fragile and must not be deformed.
Installation
Take the lamp by the base (without touching the flask with your fingers, otherwise clean it with a soft, lint-free cloth dampened with alcohol).
Insert the lamp.
Protrusion 2 should be located opposite the headlight groove.
Insert the lamp connector by turning it a quarter turn.
Note: It is not necessary to remove the headlight to remove the bulb.
After replacing the xenon lamp, it is necessary to initialize the system and adjust the headlights.
The procedure for replacing high and low beam lamps is the same as for regular headlights.