Duster Fluence Kangoo Laguna Logan Megane Sandero Scenic Symbol Clio Other

Car steering Renault Laguna 2

Adaptive Power Steering
Adaptive power steering provides greater assistance than constant power steering when the steering wheel is turned while the vehicle is stationary. As the vehicle speed increases, the assistance gradually decreases. At...

Removal and installation the steering column
Removal Place the vehicle on a two-post lift. Place the wheels in a straight-ahead position. Unlock the column. Before any operations on the airbag systems, lock the ECU using diagnostic tools. This will allow the...

Removal and installation the steering gear
Attention! The removed subframe and steering gear housing mounting bolts are not reused and must be replaced. Strictly observe the tightening torque of the bolts. Removal Place the vehicle on a two-post lift. Disconnect...

Removal and installation the inner ball joint of the steering rod
Note: The outer ball joint can be replaced without removing the steering gear from the vehicle. The Dir. 1305 tool allows you to unscrew the inner ball joints of the steering rods through the wheel arch. Removal Place...

Removal and installation the power steering pump (F9Q-F4P engines)
Removal Place the vehicle on a two-post lift. Remove: two bolts securing the power steering reservoir; right front fender liner; accessory drive belt. Install pliers Mot. 453-01 on the supply pipe. Disconnect the high...

Replacing the power steering pump pulley (F9Q-F4P engines)
Removal Depending on the design, press the pulley, having previously marked the size relative to the end of the shaft. Use a press with a puller type FACOM U 53T. Installation Press the pulley using the Dir. 1083-01...

Removal and installation of the power steering pump (K4M engines)
Removal Place the vehicle on a two-post lift. Remove: two bolts securing the power steering reservoir bracket and move it to the 8 side; fuel rail protection (two nuts); accessory drive belt using a hex wrench, which...

Removal and installation the power steering pump (L7X engines)
Removal Place the car on a lift. Remove: plastic top caps; two bolts securing the power steering reservoir; accessory drive belt; four bolts securing the pulley to the power steering pump. Install clamps Mot. 453-01 on...

Replacing the Power Steering Pump Hub (L7X Engines)
Clamp the pump in a vice on a workbench. Install the T. Ag. 1094 device in place and press the hub. Note: Install bolt 1 between the pump shaft and the pressure bolt of the T. Ag. 1094 device. Install the hub (new) and...

Checking the operation of the power steering pump
Method without using a pressure switch Install clamp Mot. 453-01 on the low pressure hose of the pump. Disconnect the high pressure line (take measures to collect the oil). Connect the pressure gauge Fre. 1085 or Fre....

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share with friends:

Other sections on other Renault models

➽ Chassis, running gear: Steering system Renault Clio 1 (1990-1998)
➽ Chassis, running gear: Steering Renault Symbol 1 (1999-2008, petrol)
➽ Chassis, running gear: Steering Renault Fluence 1 (2009-2020, petrol)
➽ Chassis, running gear: Steering Renault Sandero 1 (2007-2012, petrol)
➽ Chassis, running gear: Steering Renault Espace III (1996-2002)
➽ Chassis, running gear: Steering Renault Megan 2 (2002-2009, petrol)

Link to this section in different formats

TEXTHTMLBB Code