Steering design features Renault Logan cars are equipped with gear steering. The steering drive consists of two steering rods connected by ball joints to the steering knuckles. The steering column is safety. Most cars are equipped with power...
Removal and installation of a steering wheel You will need a TORX T50 key. 1. Disconnect the wire from the terminal «minus» battery. 2. Set the steering wheel to the position corresponding to the rectilinear movement of the car. 3. Remove the airbag module (see...
Removal and installation of a steering column You will need a key «at 13». 1. Disconnect the wire from the terminal «minus» battery. 2. Remove the steering wheel (see «Removal and installation of a steering wheel» ), having previously set it to a position...
Replacing the outer tie rod end You will need: keys «at 16», «at 19», «at 21», TORX T30, wheel bolt wrench, ball joint puller. Note. It is more convenient to perform work on a lift. You can also perform it on a car mounted on supports. The replacement...
Replacement of a protective cover of steering draft You will need side cutters. 1. Remove the steering gear (see «Steering gear replacement» ). 2. Remove the tie rod end (see «Replacing the outer tie rod end» ). 3. Use side cutters to bite the clamp securing the...
Tie rod replacement You will need a key «at 32». 1. Remove the steering gear (see «Steering gear replacement» ). 2. Remove the protective cover of the steering rod (see «Replacement of a protective cover of steering draft» ). 3. Turn out...
Bleeding the power steering system pumping (air removal) hydraulic system of the power steering is necessary after any work related to the depressurization of the system (pump or piping replacement). A sign of the presence of air in the system is the...
Steering gear replacement The steering mechanism is removed for repair or replacement, replacement of steering rods, as well as to replace damaged protective covers. However, keep in mind that the steering mechanism is the most important element...
Power steering pump replacement You will need: socket head «at 13», pliers, key for pipelines «at 17». 1. Remove the accessory drive belt (see «Replacing accessory drive belts» ). 2. Loosen the inlet hose clamp by squeezing its bent ears with pliers,...