Steering — general information Safety steering type. It consists of a gear-rack steering mechanism and a shock-absorbing steering column. The column is connected to the steering mechanism by means of an intermediate shaft with cardan joints. The...
Some steering problems Some malfunctions of a steering with the hydraulic booster and methods of their elimination
Power steering — removal and installation Steering gear: 1 - the tip of the right steering rod; 2 - right steering rod; 3, 7 - protective covers; 4 - extension of the crankcase of the steering mechanism; 5 - steering gear housing; b - gear shaft; 8 - left...
Electric power steering — removal and installation Removing put the car on a lift; disconnect the wire from the negative terminal of the battery; set the steering wheel to the position of the rectilinear movement of the car and block it; remove the front wheels; using a...
Steering wheel — removal and installation Removing set the front wheels to the straight-ahead position by inserting into the switch (lock) ignition key and release the locking device; disconnect the wire from the negative terminal of the battery; remove the...
Steering column — removal and installation Steering column: 1 - steering shaft; 2 - lever for adjusting the position of the steering column; 3 - steering column; 4 - upper cardan joint of the intermediate shaft; 5 - intermediate shaft; 6 - lower cardan joint of...
Steering column — disassembly and assembly Disassembly disconnect the wire from the negative terminal of the battery; remove the steering wheel as described above; Figure 6.6. Removing the decorative top panel of the steering column unscrew the three mounting...
Power steering pump — removal and installation Removing disconnect the wire from the negative terminal of the battery; raise the front of the car and install safety supports under the body; remove the right front wheel and mudguard (mudguard); remove the accessory...
Power steering fluid reservoir — removal and installation unscrew and remove the tank cap... take the filter out of the tank remove all the working fluid from the reservoir using a tool suitable for this (syringe, pear), then screw the lid on the tank to prevent dirt from...
Steering tip — removal and installation Figure 6.23. Fastening the tie rod end with a clamp with a bolt Figure 6.24. Attaching the tie rod end with a lock nut (arrow) On a car, two types of fastening of steering tips to steering rods are used: using a clamp...
Internal axial steering joint — removal and installation Attention! In order to avoid damage to the steering mechanism, it is recommended to use a device for removing and installing the inner ball joint of the steering rod Dir 1305-01 and Dir 1306 during work. Special tool:...
Rack Adjustment If there is play in the steering mechanism, accompanied by a knock, before deciding to replace the entire mechanism, you should make sure that the gear rack stop is correctly adjusted (pinion gear). Noise source...
Front wheel alignment Figure 6.30. Front wheel alignment Front wheel alignment is shown in Figure 6.30. Angle of longitudinal inclination of the axis of rotation The pivot point is an imaginary line drawn through the axle of the front...
Vehicle ground clearance Figure 6.31. Ground clearance measurement points. The top point of H5 is in the center of the rear arm silent block The accuracy of measuring wheel alignment angles directly depends on the ground clearance (Figure...