Removal and installation of front seats Attention! On vehicles with seat belt pretensioners, before starting work, disconnect the cable from the negative battery terminal and wait at least 5 minutes for the system to deactivate. Withdrawal procedure: install...
Removal and installation of a back of a back seat Withdrawal procedure: remove the carpet in the luggage compartment; Pic. 9.88. Detachment of the rear seat back support axle from the socket in the wheel arch on each side, release the support axle of the seat back from...
Removal and installation of the center console Pic. 9.90. Central console of the passenger compartment The view of the central console is shown in fig. 9.90. Withdrawal procedure: disconnect the wire from the negative terminal of the battery; remove the ashtray from...
Removal and installation of the instrument panel Attention! The operation of removing and installing the instrument panel requires attention and careful execution. When removing, it is necessary to remember the location of many elements in order to then correctly...
Removal and installation of a combination of devices Withdrawal procedure: disconnect the wire from the negative terminal of the battery; remove facing of racks of a windscreen, as it is described in subsection « Removal and installation of the instrument panel »; Pic....
Seat belt pretensioners To prevent injury to the driver and passenger in the front seat in the event of a frontal collision of the car, a pre-tensioning system is installed for seat belts. It automatically eliminates the insufficient tension...
Removing and attaching the seat belt pretensioner Shutdown procedure (deactivation): turn off the ignition; remove the system fuse (see section « electrical equipment »); wait at least 5 minutes before starting work; working in turn under each seat, disconnect the...
Removal and installation of the belt pretensioner assembly Withdrawal procedure: deactivate the system (see above); remove the front seat; remove the front seat cover; Pic. 9.120. Disconnecting the connector from the pretensioner assembly disconnect the wiring connector on top...
Removing and installing the pretensioner ECU Withdrawal procedure: deactivate the pretensioning system; remove the center console; Pic. 9.122. Removing the screws securing the air ducts to the computer bracket unscrew the fastening screws and move the two air...