Attention! On vehicles with seat belt pretensioners, before starting work, disconnect the cable from the negative battery terminal and wait at least 5 minutes for the system to deactivate.
Withdrawal procedure:
- install the car on a lift or overpass;
Pic. 9.84. Removing the rubber hole plugs
Pic. 9.85. Nuts of fastening of directing runners of a forward seat (numbers determine the sequence of tightening the nuts when installing the seat)
- remove the rubber plugs under the car (if provided) (pic. 9.84) and unscrew the four nuts securing the seat rails to the floor (pic. 9.85);
- carefully raise the seat, disconnecting the connectors located under the seat cushion if necessary.
Pic. 9.86. Front seat spacers
Installation is carried out in the reverse order of removal. Make sure there are spacer bushings in the car (pic. 9.86) and follow the tightening sequence of the seat nuts.
Removal and installation of skids
Withdrawal procedure:
- remove the seat as described above;
Pic. 9.87. Removing the screw securing the lining of the front seat runners
- unscrew the fixing screws (one on each side) and remove the side seat covers (pic. 9.87);
- unscrew the fixing bolts (three on each side) and remove the skids from the seat frame;
- on three-door models, disconnect the control cable from the skid assembly.
Installation is carried out in the reverse order of removal.