General information about the toxicity reduction system Strict requirements for the composition of exhaust gases imposed on cars have led to the use of devices that reduce the harmfulness of exhaust to a minimum. The described system includes an exhaust gas catalytic...
Checking and replacing components of the toxicity reduction system Catalytic Converter and Exhaust Oxygen Sensors The condition of the catalytic converter can be checked with a properly calibrated gas analyzer. Before determining the condition of the converter, it is necessary to check...
General information about the exhaust system The exhaust system consists of two sections: downpipe with catalytic converter; rear part, which includes a resonator, muffler and exhaust pipe. Pic. 3.116. Downpipe connection to the rear of the system The entire...
Removing the exhaust pipe and catalytic converter Place the vehicle on a lift or overpass. Remove the protective casing of the power unit. Withdrawal procedure: trace the wiring to the oxygen concentration sensor in the exhaust gases, disconnect the sensor connector...
Resonator replacement The back of the system is non-separable, i.e. there are no pipe connections from the resonator to the exhaust pipe, so if you need to replace any element, you should cut it out with a tool (e.g. scissors). Pic. 3.118....
Catalytic converter The catalytic converter is a reliable and simple device that does not require maintenance, but there are some points the owner should pay attention to in order to extend the life of the converter. The catalytic...
Vehicle ground clearance Pic. 6.31. Ground clearance measurement points. The top point of H5 is in the center of the rear arm silent block The accuracy of measuring wheel alignment angles directly depends on the ground clearance (pic. 6.31). To...