Description of the design of the ignition system Ignition system (K4J engine). 1 - Ignition coil, 2 - Spark plug, 3 - Magnetic sensor (BMT and Speed). Ignition system (K7J engine). 1 - Ignition coil, 2 - gearbox, 3 - Magnetic sensor (BMT and Speed). The ignition...
Precautions when working with the ignition system The voltage generated by the described electronic system is much higher than the voltage of conventional ignition systems. Make sure the ignition is off before starting work. Switch off the ignition before connecting...
K7J engine ignition coils The tightening torque of the ignition coil mounting screws is 9±1 Nm Coil monobloc type with four outputs Primary winding resistance - * 0.5 ohm Secondary winding resistance - 7.2±1 kOhm Figure 3.121. Ignition coil...
K4J engine ignition coils Torque: Ignition coil screw - 15 Nm Spark plug - 21 Nm Figure 3.122. Removing the ignition coil: 1 - contact connector; 2 - coil mounting bolt To remove the coil, disconnect the wire from the negative terminal of the...
Engine knock sensor The location of the sensor is shown in Illustration 3.104. To remove, disconnect the connector from the sensor and unscrew it from the cylinder block. Before installation, make sure that the sensor and the mounting hole...