Ignition System Specifications Characteristic Meaning Ignition timing Controlled by an electronic control module - see text Ignition coil winding resistance Characteristic Meaning E7J* engines: Primary windings Secondary windings 1.5 ohm 6.5 kOhm...
Ignition system — description and precautions The ignition system is combined with the fuel injection system, and form a single engine management system (see Chapter for more details Power and exhaust systems ). Depending on the model, there are two possible types...
Checking the ignition system Models with E7J engine Most faults in the ignition system can most often be due to loose or dirty connections. Always check all wiring carefully before testing an electrical component. The old method of testing the...
Removal, check and installation of ignition coils Removing 1. Disconnect the ground cable from the battery. Attention! If the car radio in your car is coded, make sure you know the code before disconnecting the battery. Models with E7J engine 1. The high voltage...
Removal, inspection and installation of the distributor (E7J engines) Removing 1. Remove the air filter ducts from the left side of the engine (contact the head Power and exhaust systems ). 2. Turn away screws of fastening and remove a cover from the distributor case. Move the spark plug...
Removing and installing the amplifier module (E7J engines) Removing 1. With the ignition off, disconnect the high voltage wire from the ignition coil, then disconnect the wiring connectors from the amplifier module (refer to accompanying illustration). 2. Turn away fixing nuts...
Removal and installation of the knock sensor — removal and installation Removing 1. The sensor, depending on the engine, can be located: a) E7J engines - on the rear of the cylinder block, below the intake manifold. b) K7M engines - on the back of the cylinder block, behind the starter....
Checking and adjusting the ignition timing In this type of ignition system, the ignition timing is constantly monitored by the ECU of the engine management system and cannot be verified. The only way to check the ignition timing is to use special electronic...