Removal and installation of a steering wheel Note. The horn button on models equipped with a driver's side airbag has the word "AIRBAG". A new steering wheel bolt will be required during installation. Models without airbag Removing 1. Set the front wheels to...
Removal, inspection and installation of the steering column Attention! On the models equipped with a pillow of safety see the Precautions given in the Head Onboard electrical equipment . Removing 1. Disconnect the ground cable from the battery (on Scenic models, refer to Chapter...
Removal, inspection and installation of the steering mechanism Note. When installing, you will need new nuts and bolts for securing the steering gear. Block the rear wheels, apply the handbrake, then jack up the front of the vehicle and set it on axle stands. Remove the front...
Removal and installation of the power steering pump Removing 1. Acting as described in Chapter Maintenance , loosen the auxiliary drive belt and remove the belt from the pump pulley. Please note that before removing the belt, it is necessary to loosen the bolts securing...
Bleeding the hydraulic system of the power steering This procedure is only required if hydraulic system components have been disconnected or if air has entered the system as a result of a leak. 1. Remove the tank cap and bring the liquid level to the maximum mark. The...
Replacement of a protective cover of the steering mechanism 1. Remove the ball joint of the transverse link as described in Section Removal and installation of a tip of steering draft . 2. Mark the location of the protective boot on the tie rod. Release the clamps and separate...
Removal and installation of a tip of steering draft Removing 1. Apply the handbrake, then jack up the front of the vehicle and place it on axle stands. Remove the front wheel. 2. If the ball joint cannot be replaced, use a ruler and marking tool to mark its position...
Removal and installation of transverse steering draft Note. In order not to damage the steering rack when removing the thrust, a special wrench is needed (No. Dir. 1305 according to the Renault catalog) and rail mounting clip (No. Dir. 1306 for SMI steering rack or 1306-01...