Removal and installation the center console Removal Fig. 8.91. Removing the access cover to the diagnostic connector Remove the diagnostic connector access cover (Fig. 8.91). Remove the card reader cover by pressing the spring latches (Fig. 8.92). Fig. 8.92....
Removal and installation the interior rearview mirror Removal Fig. 8.98. Disconnecting the upper trim casing Remove the upper trim casing (Fig. 8.98). Fig. 8.99. Disconnecting the lower trim casing Remove the lower trim casing (Fig. 8.99). Fig. 8.100. Disconnecting the...
Removal and installation the sun visor Removal Fig. 8.101. Disconnecting the visor retainer: 1 – retainer Disconnect the retainer (fig. 8.101). Fig. 8.102. Removing the sun visor: 1 – holder; 2 – visor Remove the holder and sun visor (fig. 8.102) Fig. 8.103....
Removal and installation the front sill trim Removal Fig. 8.104. Detaching the cladding: 1 – cladding Detach the trim (fig. 8.104). Remove the side panel of the instrument panel. Fig. 8.105. Removing the cladding: 1 – holder; 2 – cladding Disconnect the holder and...
Removal and installation the trunk mat Removal Fold down both parts of the rear seat back. Fig. 8.106. Removing the holders: 1 – holders Remove the holders using trim and panel holder removal pliers (fig. 8.106). Remove the luggage compartment mat....
Removal and installation the front seat assembly Attention! Before working with the safety system components, it is necessary to block the airbag control unit using a diagnostic device. In this case, all ignition circuits are blocked, and the airbag warning light on...
Removal and installation the front seat frame Removal Remove the seat and headrest. Fig. 8.112. Seat adjustment handle Note: Protect the seat height adjustment handle (using protective tape), give it a light blow with a wooden mallet (on the back of the handle),...