Automatic transmission Renault Megane 1

Automatic transmission specifications
Main characteristics Characteristic Meaning Designation AD4 Tightening torques Nm Characteristic Meaning Drive Disc Protective Cover Bolts 24 Drive disk mounting nuts to torque converter: early Nut (Yellow) modified...

Automatic transmission — design description
Some models with K7M and F3R engines are equipped with a four-speed automatic transmission (refer to the accompanying illustration). The transmission consists of a torque converter, an assembly of epicyclic gears,...

Replacing the transmission fluid filter
1. The filter should be replaced every time the transmission fluid is changed. 2. Drain the transmission fluid as described in Chapter Maintenance . 3. Disconnect the coolant expansion tank and move it to the side. 4....

Adjusting the length of the driving mode switch cable
1. Set the handbrake, then jack up the front of the vehicle and support it on axle stands. Remove the heat shields to gain access to the gear selector assembly. 2. Remove the center console as described in Chapter Body...

Removal and installation the drive mode selection lever assembly
1 - Handle; 2 - Screw; 3 - Top cover; 4 - Bottom cover; 5 - Bracket Removal 1. Set the handbrake, then jack up the front of the vehicle and support it on axle stands. Remove the heat shields to gain access to the gear...

Removal and installation the drive mode switch cable
Removal 1. Remove the drive mode selector lever assembly as described in Section Removal and installation the drive mode selection lever assembly . 2. Disconnect the cable from the base of the lever. 3. Using a...

Removal and installation the speedometer drive
Removal 1. The speedometer drive can be removed after removing the final drive cover from the rear of the transmission. 2. Set the handbrake, then jack up the front of the car and support it on axle stands. Where...

Replacing automatic transmission seals
Differential seal 1. Set the handbrake, then jack up the front of the car and place it on axle stands. Remove the wheel. 2. Refer to Chapter Drive shafts and separate the drive shaft assembly from the transmission. Note...

Removal and installation the transmission fluid cooler
Removal 1. The transmission fluid cooler is located on the top wall of the transmission. To access the cooler, remove the air cleaner assembly (Chapter Power supply and exhaust systems ). 2. To minimize coolant loss,...

Removal and installation of electronic components of automatic transmission
Note: After replacing any of the electronic transmission control components, the transmission no-load/full-load position must be reset. This will require special diagnostic equipment (Renault XR25). Leave this work to a...

Removal and installation of automatic transmission
Note: On models with F3R engines, it is theoretically possible to remove the transmission separately from the engine. However, this is a very complex and time-consuming procedure. It is recommended to remove the power...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share with friends:

Other sections on other Renault models

➽ Transmission: Automatic gearbox Renault Symbol 2 (2008-2013, petrol)
➽ Transmission: Automatic gearbox Renault Clio 1 (1990-1998)
➽ Transmission: Automatic gearbox Renault Sandero 1 (2007-2012, petrol)
➽ Transmission: Automatic gearbox Renault Fluence 1 (2009-2020, petrol)
➽ Transmission: Automatic gearbox Renault Laguna 2 (2001-2007)
➽ Transmission: Automatic gearbox Renault Espace III (1996-2002)

Link to this section in different formats

TEXTHTMLBB Code

Megan 2 (2002-2009, petrol)