Automatic transmission — design description Automatic transmission: 1 - valve block cover; 2 - planetary gear housing; 3 - bracket for the left suspension support of the power unit; 4 - combined multifunctional switch for selecting modes; 5 - torque converter...
Automatic transmission fluid — level check, replacement The working fluid is filled into the gearbox for the entire period of its service life. During operation, small leaks may occur, in which it will be necessary to add oil to the level. Periodically check the fluid level...
Automatic transmission valve block (DP0) Special tool: Ball plate adjusting screw - B.Vi.1462 Torque: Automatic transmission pan bolts - 10 Nm Valve block mounting bolts - 8 Nm Removing 1. Put the car on a lift. 2. Disconnect the battery. 3. Drain the...
Removing the automatic transmission Attention! If a new torque converter or transmission is to be installed, reprogram the ECU using the XR25 tester. Special tool: Subframe support - Mot. 1040-01 Ball joint puller - T.Av. 476 Brake caliper bolts - 40 Nm...
Automatic transmission selector lever Removing place the car on a lift or raise the front of the car and put the body on the safety supports; disconnect the wire from the negative terminal of the battery; remove the center console in the car (see section «...
Automatic transmission selector cable Cable adjustment Adjustment order: move the selector lever to position «N»; disconnect the end of the selector cable from the multifunction switch on top of the gearbox; Figure 4.39. Modular gearbox connector (arrow)...
Multifunctional automatic transmission switch The multi-function switch informs the ECU of the position of the gear selector lever, preventing the starter from starting when the gears are engaged, and controlling the activation of the reversing lights. The switch...
Differential seal — replacement Special tool: Mandrel for installation of an epiploon of the right power shaft — V.Vi. 1459 Mandrel for installation of an epiploon of the left power shaft — B.Vi. 1460 Tightening torques: Brake caliper bolts - 40 Nm...
Torque converter oil seal — replacement Special tool: Mandrel for installing the stuffing box - B.Vi. 1457 Oil seal extractor - Mot. 587 The oil seal is replaced on a removed automatic transmission after the removal of the torque converter. Replacement order:...
Automatic transmission sensors Figure 4.47. The location of the sensors on the gearbox: 1 – torque converter turbine rotation speed sensor; 2 – motion speed sensor; 3 – solenoid valve for cooler performance control; 4 - pressure sensor in the...