Removal and installation of the generator 1 - Generator, 2 - Starter. Removing the generator Necessary fixtures and special tools: Mot. 1273 - a device for checking the tension of the drive belt, Mot. 1505 - Tool for checking the tension of the drive belt 1....
Removal and installation of a starter Removing the starter 1. Put the car on a lift. 2. Disconnect the battery 3. Remove: right front wheel: intake silencer. 4. Work performed on the right side of the car. Remove: drive shaft pin with punch B. Vi. 31-01;...
Battery — removal and installation The car is equipped with a lead-acid battery with a nominal voltage of 12 V. Warning! Be aware that the battery contains a sulfuric acid solution (electrolyte) - an aggressive highly toxic substance that corrodes skin,...
Battery check Check for corrosion and deposits on the pallet, cover and battery terminals. If necessary, remove corrosion and wash the corroded areas with a soda solution. Clean the battery terminals and coat them with a thin layer...
Generator — check and repair The car is equipped with a three-phase alternator 100 A manufactured by Bosch. The catalog number of the generator is 0 120 416 020. The generator is driven by a multi-ribbed belt from the crankshaft pulley. Removing...
Starter — removal and installation The car uses a Valeo D7E6 starter, which is a DC motor with a traction relay. Withdrawal: put the car on a lift or raise the front of the car and put it on supports; disconnect the wires from the battery and remove it...
Replacement of starter brushes Figure 8.6. Gear starter parts: 1 - retractor relay; 2 - reducer assembly; 3 – a nut and a washer of the retractor relay; 4 - planetary gear; 5 - plate; 6 - anchor; 7 - rubber seal; 8 - back cover; 9, 19, 21 - bushings;...