Electric Power Devices Renault Fluence 1

Power supply system
The vehicles are equipped with alternators. When installing additional electrical equipment, check that the generator power is sufficient to power this equipment. The main elements of the generator are the rotor,...

Rechargeable battery
The vehicle covered in this manual has a 12-volt electrical system. The body ground is connected to the negative terminal of the battery. The battery is located in the engine compartment or under the rear seat (models...

Checking the power supply system and electricity consumers
Troubleshooting and Checking the Electrical System Check the battery, starter, and alternator terminals and cables for loose, corroded, or damaged cable terminals and wiring. Check the charging current and charging...

Checking the generator mounts
If the alternator is not installed correctly, it can cause noise from the alternator and the accessory drive belt. Also, faulty bearings and overrunning clutch can cause noise in the alternator (if installed). Make sure...

Generator replacement (all engines)
Place the car on a lift. Disconnect the wires from the battery terminals, starting with the negative terminal. Unscrew the nut (9) securing the positive terminal of the generator. Disconnect the wiring harness (10) from...

Generator pulley
Note: Always replace the alternator pulley with a breakaway clutch with the same type of pulley. Remove the generator. Secure the generator in a vice. Install the hexagonal head (1) from the alternator pulley removal...

Voltage regulator
Disconnect the negative battery cable. Remove the generator (see below). Disconnect the generator connector. Unscrew the nuts on the cover. Loosen the mounting screws and remove the cover. Remove the screws from the...

Checking the starter
Starter terminals: 1 - from the positive terminal of the battery (30); 2 — from the starter relay (50). Note: The starter ground connection is made through the gearbox and cylinder block. The starter is a DC motor that...

Starter replacement
Engine K4M Place the car on a lift. Disconnect the battery. Remove the top engine cover. Loosen the clamp securing the intake air duct to the throttle body. Disconnect the air outlet duct from the air filter housing....

Removal and installation of ignition coils (all engines)
The power module is integrated into the injection system ECU. The ignition system uses the same sensors as the injection system. Ignition coils (four, according to the number of cylinders) are secured directly to the...

Spark plugs
Replacing spark plugs Remove the ignition coils. Remove the spark plugs using a set of 16 and 21 mm torque wrenches with a torque limit of 17.5 and 28 Nm + a square adapter 9-9.52 for the Ele. 1086 (Ele. 1382) wrench...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share with friends:

Other sections on other Renault models

➽ Electrical equipment: Power devices Renault Espace III (1996-2002)
➽ Electrical equipment: Power devices Renault Scenic 1 (1996-2003)
➽ Electrical equipment: Power devices Renault Symbol 2 (2008-2013, petrol)
➽ Electrical equipment: Power devices Renault Sandero 1 (2007-2012, petrol)
➽ Electrical equipment: Power devices Renault Logan 1 (2004-2012, petrol)
➽ Electrical equipment: Power devices Renault Laguna 2 (2001-2007)

Link to this section in different formats

TEXTHTMLBB Code