Generator — Design Description and Testing Generator operation (diagnostics) These vehicles are equipped with internally ventilated generators with a built-in voltage regulator and a warning light on the instrument panel that operates as follows: when the card...
Removal and installation of the generator (engines F4P, K4M, F9Q) Removal Place the vehicle on a two-post lift. Disconnect the battery, disconnect the electrical wires from the generator. Remove: front right mudguard and side protective shield; accessory drive belt; idler pulley;...
Removal and installation the generator (engine L7X) Removal Place the vehicle on a two-post lift. Disconnect the battery. Remove the engine sump guard. Disconnect the electrical wires from the generator. Remove: accessory drive belt; power steering pump pulley;...
Removal and installation the starter (engine F9Q) Identification Removal Place the vehicle on a two-post lift. Disconnect the battery. Remove: engine cover; engine sump protection: brace 1. then catalytic converter 2. Remove: starter wiring harness; air duct A,...
Removal and installation the starter (engine L7X) Removal Place the vehicle on a two-post lift. Disconnect the battery. Remove: engine cover: engine sump protection; oxygen sensor 1 wiring connector, then remove it using tool Mot. 1495: heat shields 2 then 3; oil...
Battery — Removal, Installation and Checking Removal Before disconnecting the battery, insert the Renault card into the reader 8 position "ignition". Pull the card out to the position "accessories", now the electric lock is unlocked. Disconnect the wires from the...