Vehicle dimensions Note. Overall dimensions are indicated in footage, heights are given without vehicle load. Overall dimensions of a car with a station wagon body Overall dimensions of a car with a hatchback body
Vehicle identification The location of the identification plates on the vehicle is shown in the following figures. National type and serial number of the vehicle 1. This information is also indicated on the label (IN). 2. MTMA (Maximum...
Engine Specifications The technical characteristics of the engines are presented in the table. Engine identification data Engine identification data is stamped on the cylinder block. Engine identification data: 1 - engine type; 2 - engine...
Tire pressure Air pressure is measured with a cold tire with a full load. When measuring pressure on warm tires, take into account its increase from heating in the range of 0.2-0.3 bar. in any case, but lower the pressure.
Filling capacities and recommended consumables Refueling capacities of units and systems. Recommended operating materials. Recommended fuel Gasoline engines Use unleaded gasoline with an octane rating of at least 95 (research method). Attention! It is forbidden to...
Engine oil level In engines, oil is used to lubricate and cool moving parts; during operation, it is sometimes necessary to add oil between oil changes. If, after running in the car, the oil consumption exceeds 0.5 liters per 1000 km,...
Frequency of maintenance and name of work Frequency of maintenance and name of work Note: P* check (inspection); Z** Replace; PZ*** check (inspection) and replacement if necessary (depending on test results). Recommended operation to be carried out at a...
Replacing halogen headlight bulbs Replacing the high and side light bulb Remove cover 1. Disconnect the lamp connectors. Open the latch 2. Remove the high beam lamp. Remove the side light bulb by squeezing the socket retainers. Note. Use only approved...
Replacing xenon headlight bulbs To avoid eye injury, do not look at the xenon lamp when it is turned on (switching voltage 20000 V). Wait for the ECU components and high voltage units to cool before removing. It is forbidden to turn on a lamp that is...
Replacing taillight bulbs Disconnect the battery. Rear lights Remove the lamp holder. Remove: marker lamp 1 fog light bulb 2 reversing lamp 3 Rear fender light (hatchback modification) Remove: direction indicator lamp 4; brake light and parking...
Replacement of a lamp of a lantern of illumination of a mirror Disconnect the diffuser of the lamp 1, the lamp and the block of wires. Note. The operation of the switch can be welded through the contacts of the central fastening 1: mirror cover closed (circuit breaker open) - the...
Glove box light bulb replacement Remove the glove box liner fixing screw and glove box liner. Remove the lamp 1 by pressing the latch. Disconnect the wiring harness. Note. Use a certified C5W lamp for replacement. Fasten the wire block and the lamp...
Trunk Light Bulb Replacement Remove the luggage compartment light by pressing the latches 1. Disconnect the connector. Connect the connector after replacing the lamp. Install the luggage compartment light. Note. Use a certified C5W lamp for...
Wheel replacement Note. The method of removal and installation is the same for all spikes. Remove the decorative cap (if he is). Loosen the sprinkling of wheel bolts, while the car should be on wheels. Raise the vehicle with a portable...
Lifting equipment Roller jack and vehicle stands Note. When using a roller jack, always place props under the vehicle. Attention! It is forbidden to lift the car. by installing a jack under the front or rear suspension arm. Depending on...
Towing a car Attention! Never use the transmission components as an anchor point for the towing cable. The points used for towing can only be used for road towing. Under no circumstances may they be used to pull the vehicle out of a...