Note. The method of removal and installation is the same for all spikes.
Remove the decorative cap (if he is).
Loosen the sprinkling of wheel bolts, while the car should be on wheels.
Raise the vehicle with a portable jack.
Release the parking brake.
Note. Discs, use heads with protective pads.
Loosen the wheel bolts and remove the wheel.
Note. If after unscrewing the mounting bolts the wheel is not removed.
Screw in all bolts of fastening of a wheel and again tighten them before contact of heads of bolts with a wheel disk.
Loosen the wheel bolts one turn.
To separate the wheel, move it on the axle and, if it still does not come off, several times, not hard, tap on the circumference of the tire beads 1 from the inside and outside of the wheel.
Remove wheel bolts and wheel.
Note. Often, two types of wheel bolts are used for steel stamped and for light alloy wheels. They cannot be confused.
Before installing, center the wheel on the hub or brake drum on the mounting lug.
Install wheel bolts.
Tighten them by hand in the order shown.
Lower the vehicle to the ground, remove the jack and finish tightening the mounting bolts with a wheel wrench.
Install the wheel trim.