Height of control points of the lower part of the body Note. Tolerance:±3.5 mm. The difference between the right shoulder side of one axle of the car must not exceed 5 mm, while the driver's side must always be at a higher level. Measuring points Dimension H2 is measured...
Reference values of the angles of installation of the front wheels BGOA front wheel alignment reference values with 15 tires BGOB front wheel alignment reference values with 15 tires BGOR front wheel alignment reference values with 15 tires BGOA front wheel alignment reference values...
Specifications of wheels and tires Wheel disks There are two ways to mark wheels: stamping markings on the steel rim; casting markings on the aluminum rim. Using the marking, you can determine the main dimensions of the wheel. This designation can be...
Wheel balancing Balance weights Only use the balancing weights supplied as spare parts: mounted with spring clips on steel wheels (the latch is part of the weight); snap-mounted (flat staples) self-adhesive on aluminum wheels. A -...
Tire pressure monitoring system General information The system consists of: four pressure sensors 1 built into the valves (one per wheel) and transmitting radio signals: receiver 2 located under the vehicle. It receives and decodes the sensor signals,...
Removal and installation of pressure sensors Bead separation When separating the tire bead from the rim, be sure to start on the side opposite the valve. Make sure that the tire bead does not press on the sensor. This is necessary as the risk of damage to the...