General information about manual transmission The manual transmission of the JB3 model is five-speed, all forward gears are synchronized. The main gear and the differential mechanism are built into the gearbox. The gearbox is installed in the engine compartment...
Removing the manual transmission Attention! This subsection describes the removal of the gearbox as a separate unit with its separation from the engine installed on the vehicle. Withdrawal procedure: install the car on a lift or overpass; remove the...
Installation of a manual transmission Installation is carried out in order reverse withdrawal . Pay attention to the following: make sure the clutch release fork is properly seated on the clutch release bearing; apply a little molybdenum grease to the...
Disassembly and repair of the gearbox Repairing a box is a difficult task for a car owner. In addition to the disassembly and assembly of this assembly, which includes many small parts, you need exceptional measurement accuracy, available to specialists who...
Removal and installation of the mechanism of a gear change Withdrawal procedure: place the car on a lift or raise the front of the car and install safety supports under the body; Pic. 4.24. Removal of a cover of the handle of the gear lever inside the vehicle, carefully remove...
Adjustment of the mechanism of a gear change Operating procedure: place the car on a lift or raise the front of the car and install safety supports under the body; remove the protective cover of the power unit; remove the heat shields to gain access to the...
Check, removal and installation of the reverse light switch The reverse light switch is screwed into the left side of the gearbox housing behind the front wheel drive shaft pivot. Before removing the switch for replacement, check the integrity of the F3 fuse on the block in the...
Replacing the input shaft seal It is impossible to replace the oil seal without disassembling the gearbox, since the clutch release bearing guide sleeve is pressed into the housing and removed inside the gearbox. For these reasons, it is better to...