- make sure the clutch release fork is properly seated on the clutch release bearing;
- apply a little molybdenum grease to the splines of the input shaft of the gearbox;
- do not support the input shaft of the box on the clutch release bearing;
Pic. 4.23. Installing an additional stud (arrow) when connecting the gearbox to the engine
- make sure that the mounting sleeves are present and correctly positioned to center the engine and gearbox relative to each other. Stud installation (pic. 4.23) facilitates assembly;
- when attaching the front wheel drive shafts to the box, install new spring pins and seal them with sealant;
- check the oil level in the box and take a test drive.