Diesel engine preheating system Engine F8Q 620 The system consists of glow plugs screwed into swirl chambers, a control unit mounted on a bulkhead in the engine compartment, and a coolant temperature sensor attached to the thermostat housing. The glow...
Removal and installation the glow plug control unit Removal Engine F8Q 620 1. The block is located on the bulkhead of the engine compartment (refer to the accompanying illustration). 2. Disconnect the ground cable from the battery. 3. Unscrew the mounting nut and remove...
Adjustment, testing, removal and installation of the glow microswitch Note: The dual function glow plug and EGR switch is only fitted to the F8Q 620 engine. Adjustment 1. The engine must be off. Press the throttle lever all the way down and insert a 5 mm thick feeler gauge between the...
Checking, removing and installing the coolant temperature sensor Note: You will need an ohmmeter to check for proper operation. Examination 1. On the F8Q 620 engine, the sensor has two functions. The NTC resistor tells the heater control unit the coolant temperature, and the switch...
Fuel filter heating system with glow plug system An electric heating element is installed in the fuel filter housing, which prevents the fuel from thickening at low temperatures. The heater is controlled by a thermal switch. When the fuel temperature is below 0°C, the...
Removal, inspection and installation of glow plugs Removal 1. Disconnect the ground cable from the battery. Warning: If the car radio in your car is coded, make sure you know the code before disconnecting the battery. 2. When working on the F9Q engine, remove the...