Features of the design of the gearbox 6.3. Transmission: 1 - back cover; 2 - gearbox housing; 3 - filler plug; 4 - clutch release fork; 5 - clutch housing; 6 – speed sensor; 7 - gearbox control lever; 8 – a stock of a choice of transfers; 9 - gear lever; 10...
Replacing gearbox seals The input shaft oil seal is installed in a non-separable assembly of the clutch release bearing guide bushing together with the input shaft front bearing. The guide bushing block is pressed into the clutch housing....
Removal and installation of a transmission The main malfunctions, for the elimination of which it is necessary to remove the gearbox from the car: elevated (compared to usual) noise; difficult gear shifting; spontaneous disengagement or fuzzy engagement of...
Replacing the transmission control drive rod Gearbox control rod is removed if it is damaged (for example, if the threads on the gear lever mounting pin are bent or damaged) or to replace the bushings in the lower head of the gear lever, as well as when removing...
Removal, installation and repair of the scenes of the gear lever Repair of the linkage of the gearbox control lever consists in replacing the control lever in case of vibrations and increased play of the lever caused by wear of its ball bearing. The lever can be replaced without...
Gearbox control drive adjustment To adjust the gearbox control drive, the manufacturer provides special devices for fixing the drive elements in a certain position. Therefore, in case of violation of the adjustment, which does not allow the inclusion...