General information of the lubrication system Note: When selecting engine oil, it is imperative to take into account not only the grade, but also the specification. For example: 5W40 RN0710. The manufacturer recommends using, both for refueling and for replacement,...
Draining and refilling engine oil Attention: Wear leak-resistant nitrile gloves. Check the oil level with the dipstick. Do not exceed the maximum level (top mark on dipstick), it can destroy the engine. Note: When filling the engine with oil, be sure to...
K7M engine (1.6 l, 8 valves) Draining the engine oil and removing the oil filter 1. Place the vehicle on a two post lift. 2. Unscrew the fastening bolts and remove the engine protective tray. 3. Remove the oil fill cap (1) and oil dipstick (2). 4....
K4M engine (1.6 l, 16 valves) Draining the engine oil and removing the oil filter 1. Place the vehicle on a two post lift. 2. Unscrew the fastening bolts and remove the engine protective tray. 3. Remove the oil fill cap (1) and oil dipstick (2). 4....
K9K engine (1.5 l) Draining the engine oil and removing the oil filter 1. Place the vehicle on a two post lift. 2. Unscrew the fastening bolts and remove the engine protective tray. 3. Remove the cover with the dipstick (1). 4. Place an...
Engine Oil Pressure Check Engine Oil Pressure Check Procedure 1. Place the vehicle on a two post lift. 2. Disconnect the negative battery terminal. 3. Unscrew the fastening bolts and remove the engine protective tray. 4. Engine D4F: unscrew the...
Engine oil pan Caution: Use leak-resistant nitrile gloves for handling. Note: The engine oil pan is sealed with silicone during manufacture. When removing the oil pan in the workshop, a sealant must be used, which can be ordered from...
Engine oil pump Note: Prepare for engine oil leakage by placing a suitable oil pan under the engine. D4F engine (1.2 l) Removing the oil pump 1. Place the vehicle on a two post lift. 2. Disconnect the negative battery terminal. 3....
Engine oil pressure sensor D4F engine (1.2 l) Removing the oil pressure sensor 1. Place the vehicle on a two post lift. 2. Unscrew the fastening bolts and remove the engine protective tray. 3. Loosen the bolts (1) and remove the heat shield (2)....
Turbocharger oil line (only diesel engine K9K) Attention: Wear leak-resistant nitrile gloves. Ensure that foreign objects do not enter the turbine or compressor during installation. Metal objects that enter the oil or air circuits of the turbocharger can cause...
Cooling system special tools and accessories Name of tool and fixtures Catalog number Oil filter wrench (diameter 76 mm) Mot. 1329 Oil filter wrench (diameter 66 mm) Mot. 1330 Drain plug wrench with 8 mm square Mot. 1018 22 mm socket wrench for removing and...