Car front and rear suspension Renault Logan 2

Suspension — General Information
Note: : replace the part with a new one after each removal. : a special tool/device must be used. : observe the tightening sequence. : apply a special compound. Front suspension components: 1. Front subframe. 2. Rubber...

Precautions during repair
When performing any work related to lifting a vehicle on a lift, observe the relevant safety regulations. Do not press the brake pedal when working on the brake system. If, during the work on the brake system, any...

Removal and installation the front subframe
Removal the front subframe 1. Place the vehicle on a two-post lift. 2. Disconnect the negative battery terminal 3. Loosen the steering gear universal joint bolt 4. Remove the front wheels from the vehicle. 5. Remove the...

Removal and installation the front suspension strut
Removal the front suspension strut 1. Place the vehicle on a two-post lift. 2. Unlock the steering column. 3. Remove the front wheel from the corresponding side of the vehicle. 4. Use a marker to mark the position of...

Removal and installation the front wheel bearing
Attention: To avoid permanent damage to the front hub bearing: Do not loosen or tighten the drive shaft nut when the vehicle wheels are on the ground. Do not place the vehicle with its wheels on the ground when the...

Removal and installation the rear suspension beam
Caution: Provide a suitable tray to collect any leaking liquid and take measures to protect surrounding components. Removal the rear suspension beam 1. Release the parking brake. 2. Place the vehicle on a two-post lift....

Removal and installation rear shock absorbers
Removal the rear shock absorber 1. Place the vehicle on a two-post lift. 2. Partially remove the rear fender liner. 3. Place the car on the ground with its wheels, unscrew the nut (1) in the luggage compartment and...

Removal and installation rear suspension rubber bushings
Removal the rear suspension rubber bushing 1. Place the vehicle on a two-post lift. 2. Remove the rear wheels from the vehicle. 3. Remove the rear brake drums (see chapter " Brake system "). 4. Remove the rear...

Removal and installation the rear wheel bearing
Removal the rear wheel bearing 1. Place the vehicle on a two-post lift. 2. Remove the rear wheel and brake drum (see chapter " Brake system ") on the corresponding side of the vehicle. 3. Remove the bearing retaining...

Checking wheel alignment angles
1. Raise the car with a lift. 2. Check the condition of the following components: suspension arms; longitudinal rods with ball joints; subframe; rubber bushings of lower suspension arms; lower ball joints (see chapter "...

Wheel alignment angles of a car
Front wheels of the car Note: All values are for the vehicle's unladen weight. Wheel alignment To adjust the front wheel alignment: Set the front wheels of the vehicle to the straight-ahead position. Lock the steering...

Steering Angle Sensor Calibration
After adjusting the wheel alignment angles, it is necessary to calibrate the steering wheel angle sensor. 1. Connect the diagnostic tool. 2. Select "Braking computer" (brake system processor). 3. Go to repair mode...

Removal and installation wheels
Note: Wheel removal and installation procedures are the same for all wheel types. Removal a wheel from a car 1. Place the vehicle on a two-post lift. 2. Release the parking brake. 3. Remove the wheel cap. 4. Place the...

Car tires
Note: The decoding of the tire designation is given using the example of the identification mark 205/65 R 15 91 V. 205 Tire width in mm 65 Aspect ratio of the aspect ratio of the tire R Radial arrangement of tire cord...

Wheel rims
There are two types of wheel rim designations: engraved marking for steel wheels; cast marking for light alloy wheels. The markings indicate the main parameters of the wheel disk. Marking can be complete (for example, 6...

Special tools and devices
Name of tools and devices Catalogue number Ball joint puller Tav. 476 Support for removing/installing the engine with gearbox assembly Mot. 1390 Threaded rods for performing work on the subframe Tav. 1747 Device for...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share with friends:

Other sections on other Renault models

➽ Chassis, running gear: Car suspension Renault Laguna 2 (2001-2007)
➽ Chassis, running gear: Car suspension Renault Clio 1 (1990-1998)
➽ Chassis, running gear: Car suspension Renault 19 (1988-1996)
➽ Chassis, running gear: Car suspension Renault Symbol 1 (1999-2008, petrol)
➽ Chassis, running gear: Car suspension Renault Scenic 1 (1996-2003)
➽ Chassis, running gear: Car suspension Renault Kangoo 1 (1997-2007)

Link to this section in different formats

TEXTHTMLBB Code