Disconnect the battery and headlight connectors.
Attention! Xenon lamps light up when a voltage of 20,000 V is applied and operate at an alternating voltage of 85 V. Therefore, before removing it, it is necessary to disconnect the headlamp connector and wait until the computer has cooled down. It is forbidden to turn on the lamp if it is not installed in the headlight (it's dangerous for the eyes).
Remove:
- engine crankcase protection;
- radiator lining;
- front bumper;
- two upper guides A of the bumper.
Remove screws C.
Disconnect clip B on each headlight assembly.
Take out the headlight.
After installing the headlights, you need to adjust them. Adjustment is carried out in the following order:
- place the car on a flat surface;
- make sure that the car is unloaded, while the fuel tank must be full (if possible);
- set the corrector knob to position «ABOUT»;
- adjust headlight beam
- in the vertical plane with screw D;
- adjust the headlight beam.
in a horizontal plane with screw E.
If the car is equipped with xenon headlights, then it is necessary to initialize the system and adjust the headlights (see section «Xenon headlights, system initialization»).
Mounting brackets
Cracks in the headlight brackets can be repaired using the kit supplied as spares, but only if there are no chips.
Install the repair bracket in the correct position, drill a hole in the right place and connect with a 5x11 countersunk rivet.