Adjusting the leaf spring lever (Renault Laguna 2)

Hold the multifunction switch lever in the extreme position (in the forced first gear position) using a plastic clamp and a bolt screwed into the gearbox housing.



Unscrew bolt 1.



Install the leaf spring lever by inserting the roller into the recess of the sector corresponding to the forced engagement of the first gear.

Screw in the lever bracket mounting bolt without tightening it.



Install the tool (Bvi. 1462) in place of bolt 1.





While holding the lever, screw the device in until it stops.

Tighten the leaf spring lever bracket mounting bolt to the specified torque (9 Nm).

Remove the tool (Bvi.1462). Install the lever mounting bolt.

Tighten the lever mounting bolt to the specified torque (8 Nm).

If the hydraulic distributor is replaced, reset the self-tuning parameters using the command: RZ005 "Resetting self-tuning parameters" and reset the automatic transmission oil service life counter using the diagnostic tool by entering the command: CF074 "Record gearbox oil change date".

After executing command RZ005, be sure to drive the vehicle with multiple upshifts and downshifts to memorize the new values and settings.

Tighten to the specified torque:

• cover mounting bolts (10 Nm);
• battery (40 Nm);
• amplifier mounting bolts (21 Nm).

Installation is carried out in the reverse order of removal.

(Source link is located on: Renaultbook.ru)