Share with friends:
Doors, locks and windows of the car Renault Kangoo 1
Front door protective pads
Removal 1. Remove bolt A. 2. Move the trim to the rear of the vehicle 1. Attention! Holders B cannot be removed without damage, so they must be replaced each time they are removed. 3. Remove both spring holders C, then...
Removal 1. Remove bolt A. 2. Move the trim to the rear of the vehicle 1. Attention! Holders B cannot be removed without damage, so they must be replaced each time they are removed. 3. Remove both spring holders C, then...
Rear door protective pads
Removal 1. Move the trim towards the front of the vehicle in direction 2. 2. Remove the brackets as shown above. Installation see p. 10.2 Installation .
Removal 1. Move the trim towards the front of the vehicle in direction 2. 2. Remove the brackets as shown above. Installation see p. 10.2 Installation .
Crossbar of the opening roof section
Removal 1. Remove the plug and fastening nut A. 2. Disconnect rod B from its support. 3. Remove the mounting nut from the crossmember.
Removal 1. Remove the plug and fastening nut A. 2. Disconnect rod B from its support. 3. Remove the mounting nut from the crossmember.
Front door
Removal 1. Disconnect the door wire connector by pressing the connector latches upward. 2. Unscrew bolt A securing the door opening limiter. 3. Knock out the hinge pins using the Sag. 1415 device (the operation is...
Removal 1. Disconnect the door wire connector by pressing the connector latches upward. 2. Unscrew bolt A securing the door opening limiter. 3. Knock out the hinge pins using the Sag. 1415 device (the operation is...
Side sliding door
Removal 1. Remove the back stop. 2. Remove the axle. Installation The door is installed in the reverse order of removal, and the door must be adjusted. Adjustment 1. To ensure clearances B and D, adjust the position of...
Removal 1. Remove the back stop. 2. Remove the axle. Installation The door is installed in the reverse order of removal, and the door must be adjusted. Adjustment 1. To ensure clearances B and D, adjust the position of...
Tailgate
Lifting door Removal/Installation 1. Remove the upholstery. 2. Disconnect the door electrical wiring. 3. Remove the gas-filled struts 4. Loosen the mounting bolts A on the rear roof beam (this operation must be...
Lifting door Removal/Installation 1. Remove the upholstery. 2. Disconnect the door electrical wiring. 3. Remove the gas-filled struts 4. Loosen the mounting bolts A on the rear roof beam (this operation must be...
This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
Other sections on other Renault models
➽ Body and interior: Doors, locks and windows Renault Logan 1 (2004-2012, petrol)
➽ Body and interior: Doors, locks and windows Renault Sandero 1 (2007-2012, petrol)
➽ Body and interior: Doors, locks and windows Renault Symbol 2 (2008-2013, petrol)
➽ Body and interior: Doors, locks and windows Renault Scenic 1 (1996-2003)
➽ Body and interior: Doors, locks and windows Renault Clio 1 (1990-1998)
➽ Body and interior: Doors, locks and windows Renault Fluence 1 (2009-2020, petrol)
Link to this section in different formats
TEXTHTMLBB Code
- General information
- User manual
- Maintenance
- Power unit
- Petrol engine D7F
- Petrol engine E7J
- Diesel engine F8Q
- Transmission
- Clutch
- Car gearbox
- Drive shafts
- Chassis, running gear
- Car suspension
- Steering
- Brake system
- Body and interior
- Exterior and interior
- Doors, locks and windows
- Electrical equipment
- Equipment and devices
- Electrical circuits