Removing
1. Disconnect the door wire connector by pushing the connector latches up.
2. Turn away a bolt And fastenings of the limiter of opening of a door.
3. Knock out the hinge pins using the Sag tool. 1415 (the operation is performed by two).
Installation
Installation of a door is made in an order, the return to removal. Adjust the clearances specified in clause 10.14.
Power window handle
Removing
Remove the handle by placing a piece of cloth 1 to protect the upholstery and placing a spacer between the cloth and the tool. Use a homemade fork tool or FACOM D115 tool as a lever.
Note You can use upholstery fastener pliers to perform this operation.
Power window
Removing
1. After removing the door upholstery, lower the glass to the lower position, remove the mechanism mounting parts.
2. Release the mechanism from the glass.
3. If this vehicle has a power mechanism, disconnect the wiring harness.
4. Remove the power window mechanism.
Internal lock drive handle
Removing
1. Remove fixing screw 1.
2. Release drive link 2.
Lock
Removing
1. Remove the upholstery.
2. Remove the safety cover 1 of the lock.
3. Remove the guide of the inner wings A.
4. Disconnect the latch drive rod and the outer handle of the door lock.
5. Remove the lock fixing screws B.
6. If this vehicle is equipped with a power mechanism, disconnect the wiring harness.
External handle
Removing
1. Remove upholstery and safety cover.
2. Remove the handle mounting bolt.
3. Disconnect the latch rod and the outer handle of the door lock.
Lock cylinder
Removing
1. Remove the outside handle.
2. Remove the lock cylinder by tightening the retaining spring.