Required Tool
- T. Av. 1168 Clamp cutters CAILLAU.
- T. Av. 1256 Crimping tool OETIKER.
- T. Av. 1331 Mandrel for installing the hinge boot.
1 - Three-thorn;
2 - Rubber cover;
3 - Support ring;
4 - Holder;
5 - Dirt deflector;
6 - Retaining ring;
7 - Drive shaft.
Removing
1. Remove the retaining ring.
2. Using a press and a puller, remove the three-stud.
Note. Mark the position of the three-stud before removing.
3. Remove the cover and deflector in the same way as for the 3-stud.
Installation
1. For an exact location on the shaft, the bearing must be pressed onto it until the dimension L = 118±0.2 mm is obtained between the rear end of the bearing and the end of the shaft. This dimension is obtained by using a T.Av. 1331 when its end is flush with the end of the shaft.
Note. To avoid deformation of sealed bearings and therefore the risk of grease leakage, do not press the bearing in with a hammer, but only with a press so that the applied force can be gradually increased.
3. For pressing, the shaft should be held by the recess G with a puller.
Install the three-stud in the position marked before removal and secure the retaining ring.