Dashboard (Renault Kangoo 1)

Removal

1. Disconnect the battery.

2.1. Removing the steering wheel (with airbag).



Remove the two airbag mounting screws located behind the steering wheel. Disconnect the electrical connectors. Remove the airbag. Remove the steering wheel bolt (when assembling the steering wheel, this bolt must be replaced, tightening torque 45 Nm). Remove the steering wheel, having first set it to the position corresponding to straight-ahead movement.

2.2. Removing the steering wheel (without airbag).

Remove the center trim. Remove the steering wheel bolt (when assembling the steering wheel, this bolt must be replaced, tightening torque 45 Nm). Remove the steering wheel, having first set it to the position corresponding to straight-ahead movement.





3. Remove the upper and lower casings (3 screws).



4. Remove the instrument cluster visor (6 screws) and the instrument panel visor (2 screws).



5. Remove the instrument panel from the screw.



6. Disconnect the electrical connectors.





7. Before removing the device kit under the steering wheel of a vehicle with an airbag, be sure to mark the position of the rotating contacts:

• make sure the wheels are set in the straight ahead position;
• fix the rotating contact rotor with adhesive tape.

8. Loosen the screw, then tap the screwdriver lightly to release the cone.

9. Disconnect the electrical connectors.



10. Remove the bottom cover (4 screws).



11. Remove the lower part of the instrument panel (4 screws, 2 fasteners).





12. Remove the fuse box panel (5 screws).

13. Disconnect the diagnostic connector.



14. Remove the steering column fasteners (2 bolts, 2 nuts).



15. Remove the ashtray and its support.

16. Disconnect the electrical connectors.



17. Remove the heater control unit (2 screws).





18. Remove the speaker grille.

19. Remove the instrument panel clips.

20. Pull the panel slightly.

21. Loosen the clamps securing the electrical wires.

22. Disconnect the electrical connectors of the headlight range control and indicator devices.

23. Disconnect the remaining electrical connectors.

24. Remove the instrument panel.

Installation

Installation is carried out in the reverse order of removal.